Godox WEC-CS Microphone System 2 Kit Owner’s Manual

August 22, 2024
Godox

Godox WEC-CS Microphone System 2 Kit

Foreword
Thank you for purchasing! WEC-CS is the charging case of Godox’s latest wireless lavalier microphone system for Sony cameras. It has three built-in slots, which can store and charge three devices at the same time. Three internal status indicators conveniently show charging status of the devices, while the external charging indicators clearly show the battery level of itself. Please read this manual carefully before using to make sure the correct operation and exert the optimum function.

Main Features

  • Built-in lithium battery can charge three devices at the same time.
  • Three internal status indicators show charging status of the devices.
  • External charging indicators show the battery level of itself.
  • Support charging through USB-C cable.

Warning

Do not disassemble. Should repairs become necessary, this product must be sent to our Company or an authorized maintenance center.
Always keep this product dry. Do not use in rain or damp conditions.
Do not leave or store this product in the environment of direct sunlight, near heating devices, or in hot, humid or dusty.
Keep out of reach of children.
Do not use in flammable and explosive environments. Pay attention to the relevant warning signs.
Do not leave or store the product if the ambient temperature reads over 50
& Please read carefully and follow the warnings or instructions provided by the manufacturer.

Structure of Product

  1. Transmitter’s Slot
  2.  Receiver’s Slot
  3. Internal Status Indicator 6. Reset Hole
  4. External Charging Indicator
  5. USB-C Charging Port
  6.  Reset Hole

What’s Inside

Note: Due to continuous updates and upgrades of the products, there may be differences between the actual products and the pictures. Therefore, the pictures are for reference only, products to prevail in kind.

Instructions for Use

Put the transmitter/receiver into the charging case, the case will first detect whether the transmitter/receiver is correctly inserted into the corresponding slot, the corresponding internal indicator will light up if the pins inside touched the charging points of the transmitter/receiver. Then it will detect whether the transmitter/receiver is fully charged, if not, it will start charging until it’s fully charged. The internal status indicators and external charging indicators will light up at the same time to show the battery level of the transmitter/receiver and the charging case itself if the charging case lid is open.
When charging the case itself, the four external charging indicators will flash white incrementally, and be constant on white after the charging case is fully charged.

Indicator Status Meaning
Internal status indicator flashes white The transmitter/receiver being

charged
Internal status indicator is constant on white| The transmitter/receiver is fully charged
Four external charging indicators are constant on white| Charging case battery level is 100%
The first three external charging indicators from left to right are constant on white after the lid is open, while the last one is off| Charging case battery level is 75%
The first two external charging indicators from left to right are constant on white after the lid is open, while the other two are off| Charging case battery level is 50%
The first external charging indicator from left to right is constant on white after the lid is open, while the last three are off| Charging case battery level is 25%
The first external charging indicator from left to right flashes white after the lid is open, while the last three are off| Charging case battery level is low, please charge in time
Four charging indicators are all off after the lid is open| Charging case battery level is 0%, it will automatically turn off

Technical Data

Name Model Charging Case WEC-CS
Lithium Battery Parameters 3.7V=1400mAh. 5.18Wh
USB-C Input 5V=1.3A
Working Time Charge 3 devices for about twice
Charging Time Approx. 2h
Working Environment Temperature -10~50°C
Dimension 2.48″x3.35″x1.42″
Net Weight 87g

Specifications and data may subject to changes without notice.
Maintenance

Avoid falling. Strong collision or vibration may malfunction the device. Keep dry. This product is not water-proof. Malfunction, rust, and corrosion may occur and go beyond repair if soaked in water or exposed to high humidity.

Avoid sudden temperature changes. Condensation happens in sudden temperature changes such as the circumstance when taking the product out of a building with higher temperature to outside in winter. Please put the product in a handbag or plastic bag beforehand. Keep away from strong magnetic field. The strong static or magnetic field produced by devices such as radio transmitters leads to malfunction. Specifications and data may subject to changes without notice.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1.  This device may not cause harmful interference, and
  2.  this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • * Reorient or relocate the receiving antenna.
    • Increase the separation between the equipment and receiver.
    • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
    • Consult the dealer or an experienced radio/TV technician for help.

Declaration of Conformity
GODOX Photo Equipment Co.,Ltd. hereby declares that this equipment are in compliance with the essential requirements and other relevant provisions of Directive 2014/35/EU,2014/30/EU. They are allowed to be used in all EU member states. For more information of DoC, Please click this web link: https://www.godox.com/eu-declaration-of-conformity

Warranty

Dear customers, as this warranty card is an important certificate to apply for our maintenance service, please fill in the following form in coordination with the seller and safe-keep it. Thank you!

Product Information Model                    I Product Code Number
Customer Information Name                    I Contact Number

Address
Seller Information| Name
Contact Number
Address
Date of Sale
Note

Applicable Products I

The document applies to the products listed on the Product Maintenance Information (see below for further information). Other products or accessories (e.g. promotional items,giveaways and additional accessories attached,etc.) are not included in this warranty scope.

Warranty Period I

The warranty period of products and accessories is implemented according to the relevant Product Maintenance Information. The warranty period is calculated from the day(purchase date) when the product is bought for the first time, and the purchase date is considered as the date registered on the warranty card when buying the product.

How to Get the Maintenance Service I
If maintenance service is needed, you can directly contact the product distributor or authorized service institutions. You can also contact the Godox after-sale service call and we will offer you service. When applying for maintenance service, you should provide valid warranty card. If you cannot provide valid warranty card, we may offer you maintenance service once confirmed that the product or accessory is involved in the maintenance scope, but that shall not be considered as our obligation

Inapplicable Cases I
The guarantee and service offered by this document are not applicable in the following cases:

  1. The product or accessory has expired its warranty period;
  2. Breakage or damage caused by inappropriate usage, maintenance or preservation, such as improper packing, improper usage, improper plugging in/out external equipment, falling off or squeezing by external force, contacting or exposing to the improper temperature, solvent, acid, base, flooding and damp environments, etc;
  3. Breakage or damage caused by non-authorized institu- tion or staff in the process of installation, maintenance, alternation, addition and detachment;
  4. The original identifying information of product or accessory is modified, alternated, or removed;
  5. No valid warranty card;
  6. Breakage or damage caused by using illegally authorized, nonstandard or non-public released software;
  7. Breakage or damage caused by force majeure or accident;
  8. Breakage or damage that could not be attributed to the product itself.

Once met these situations above, you should seek solutions from the related responsible parties and Godox assumes no responsibility. The damage caused by parts, accessories and software that beyond the warranty period or scope is not included in our maintenance scope. The normal discoloration, abrasion and consumption are not the breakage within the maintenance scope.

Maintenance and Service Support Information

The warranty period and service types of products are implemented according to the following Product Maintenance Information·

Product Type Name Warranty Service Type
Parts Product Main Body 12 Customer sends the product to designated site
Battery Customer sends the product to designated site
Charger, Electrical Parts etc. 12 Customer sends the product to designated

site
Other Items|

Battery Case, Windscreen Foam, Wind Cap, Locking Device, Lanyard, Tie, Velcro Tape, Clip, Bag, Package etc

| No| Without warranty

Godox After-sale Service Call 0755-29609320-8062
Godox Audio Wechat Official Account

Overseas Official Accounts & Updates

GODOX Photo Equipment Co., Ltd.
Address: Building 2,Yaochuan Industrial Zone, Tangwei Community, Fuhai Street, Bao’an District, Shenzhen 518103, China
Tel: +86-755-29609320(8062)
Fax: +86-755-25723423
Email: aodox@aodox.com
Website: www.godox.com
Made in China | 705-WECCS0-00

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals