RODE RCPDUO Integrated Audio Production Studio User Guide

: August 20, 2024
: Rode

Table of Contents

RCPDUO Integrated Audio Production Studio
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

QUICK START GUIDE

RCPDUO Integrated Audio Production Studio

Connect the included power supply to your RØDECaster Duo, press the adjacent red power button and follow the start-up walkthrough
Connect your microphones to the XLR inputs on the rear and adjust the corresponding faders to increase or decrease input level
Connect your headphones to the 1/4-inch outputs on the rear and adjust the corresponding knobs to increase or decrease headphone volume
View the online user guide for more information on how to master your RØDECaster Duo

Download RØDE Central to customise SMART Pads, transfer recordings, configure settings and update firmware for your RØDECaster Duo: rode.com/apps/rode- central
The RØDECaster DUO must not be co-located or operated in conjunction with any other antenna or transmitter.
The device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures:

Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help

This equipment complies with FCC radiation exposure limits set forth in an uncontrolled environment.
Changes or modifications not expressly approved by RØDE could void the user’s authority to operate the equipment.
For USA: The frequency stability of all transmission frequencies of U-NII-1, U-NII 2A, U- NII 2C and U-NII-3 meets the requirements of 47 CFR FCC Part15.407(g), and the manufacturer declares that their transmission is maintained at Band U-NII-1, U-NII 2A, U-NII 2C and U-NII-3.
For Canada: The frequency stability of all transmission frequencies of U-NII-1, U-NII 2A, U- NII 2C and U-NII-3 meets the 47 CFR FCC Part15.407(g) requirements, and the manufacturer states that their transmissions remain within the U-NII-1, U-NII 2A, U-NII 2C and U-NII-3 bands.
CAN ICES-3 (B) / NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference
This device must accept any interference, including interference that may cause undesired operation of the device

RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.
Radio Frequency Exposure Statement for Canada
The device has been evaluated to meet general RF exposure requirements. The device can be used in mobile exposure conditions. The minimum separation distance is 20cm
Operation of this device is restricted to indoor use only. (W52 band)

EU COMPLIANCE STATEMENT
Hereby, RØDE Microphones declares that the radio equipment type RØDECaster DUO is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: https://info.rode.com/rodecaster-duo
For details of EU representative go to http://en.rode.com/distributors

CAUTION:
The RØDECaster Duo has been designed to be used with the provided power supply, as use the provided power supply only.
Stop using the power supply unit and any cables if:

There is any damage to the charging port, power connector or power cord
The power supply unit is exposed to excessive moisture, or liquids is spilled into the power supply unit
The power supply unit enclosure is broken

Operating Frequency Range	The maximum RF Output Power
Bluetooth 2402-2480 MHz	3.68 dBm (BR/EDR)

POWER SUPPLY UNIT SPECIFICATIONS:
Model Name: YDS-PD030A
Frequency: 50-60 Hz
Line Voltage: 100-240 Vac
Output Ratings: 20Vdc 1.5A; 15Vdc 2.0A;
12Vdc 2.5A; 9Vdc 3A; 5Vdc 3A

Equipment name	Podcast Workstation	Type designation (Type): RODECASTER DUO
Unit	Restricted substances and its chemical symbols
Lead (Pb)	Mercury (Hg)	Cadmium (Cd)

Polybrominated
biphenyls (PBB)| Polybrominated diphenyl ethers (PBDE)
Shell| ◯| ◯| ◯| ◯| ◯| ◯
Wire| ◯| ◯| ◯| ◯| ◯| ◯
Printed circuit board (Including plug-ins)| ◯| ◯| ◯| ◯| ◯| ◯
Label| ◯| ◯| ◯| ◯| ◯| ◯

Note 1: “Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the percentage content of the restricted substance exceeds the reference percentage value of presence condition.
Note 2: “◯” indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence.
Note 3: The “－” indicates that the restricted substance corresponds to the exemption.

USA	FCC ID: 2AEAN-RCDUO
CANADA	IC: 20091-RCDUO

R-41263699
MEXICO|
POWER| 9Vdc 3A

To prevent possible hearing damage, do not listen at high volume levels for long periods.

RØDE Microphones:
107 Carnarvon St, Silverwater NSW 2128, Australia
Authorised UK Representative:
RØDE UK, Unit A, 23-25 Sunbeam Rd, London
NW10 6JP, United Kingdom
Authorised EU Representative:
RØDE EU, Neukirchner Str. 18, 65510 Hünstetten, Germany

SCAN FOR MORE INFO

https://info.rode.com/rodecaster_duo
View the user guide to learn morerode.com
0927-0840-03-01