n-com SPCOM00000072 Connector Cover Instructions
- June 3, 2024
- N-Com
Table of Contents
n-com SPCOM00000072 Connector Cover
INSTRUCTIONS FOR REPLACING THE SPCOM00000072
- Remove the N-Com system from the helmet (Fig. 1-3).
- Remove the screws using a Torx T6 screwdriver and move the plastic cover from its housing (Fig. 4).
- Position the new connector cover cap in its housing (Fig. 5).
- Reposition the protection cover, matching up the two holes where the screws pass through. Replace the screws and tighten them (Fig. 6).
- Reposition the N-Com system inside the helmet (see instruction booklet).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>