RTA RVQ_10303 Table for TV Volanno Instruction Manual
- August 14, 2024
- RTA
Table of Contents
RTA RVQ_10303 Table for TV Volanno
ATTENTION!
On the next pages is the content of the pieces and hardware of the furniture. Make sure the number of hardware and parts in the box is correct and everything is in good condition. When the furniture is assembled you will not be able to make any replacement
Key Recommendations
- Assemble the cabinet between two people.
- Assemble the cabinet on a flat smooth surface, preferably on a carted floor or the box carton.
- It is recommended to use an electric screwdriver to facilitate assembly.
Required Tools
-
Phillips Head Screwdriver
-
Flat Head Screwdriver
-
Hammer
Basic Hardware
Apply these instructions every time you’re using one of these connectors during the assembly.
Wood Dowels
- Put in the dowel inside the indicated hole and softly hit it until it’s fully inside.
- Verify that the dowel is NOT inserted into the perforation of the mini fix cam.
Mini fix Cam & Spreading Bolt
-
The Mini fix cam has a little arrow on its upper surface you should insert these cams with the little arrow pointing towards the drilling on the panel’s edge.
-
The spreading bolt should be put with the black plastic part facing down. edge.
-
After joining two panels together you should turn the cams 180° with a phillips head screwdriver to adjust and secure the joint.
Hardware
-
Wood dowel x10
-
Spreading Bolt x20
-
Mini fix Cam x20
-
Cover Caps x20
-
Shelf support x1
-
Handle x1
-
Inset overlay hinge + screws x2
-
Leg x5
-
Flat Head Screw x30
-
Flat Head Screw x8
-
Back Panel Support x8
-
Corners backet x4
Max Suggested Loads
Weight in Kg
Weight in Lb
Assembly Parts
- A – x1
- B – x1
- C – x1
- D – x1
- E – x1
- F – x1
- G – x1
- H – x1
- I – x1
- J – x1
Place the corner supports in the corners and screw with flat head screw 9/16″
- Corner Support
Flat head screw 9/16″
Flat screws 9/16″.
- Back Panel Support
Insert the back panel supports between the grove and the back panel.
Fix the back panel supports whit 3/4″ flat head screws.
Door Installation
Follow the adjustment instructions on the next page.
Hinge adjustment
Depth adjustment
|
Side adjustment
|
Height adjustment
---|---|---
| |
| |
| |
Screws adjustment
Use the settings according to the specific need.
After you finish the adjustment of the cams and screws, cover them with the cover caps.
After you finish assembling the cabinet, take off the adhesive letters.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>