MotoTec 1800w Electric Trike User Guide

MotoTec 1800w Electric Trike

WARNING
CHOKING HAZARD-Small parts. Not for those under 16 years old.

TECHNICAL INFORMATION

• Motor power: 1800-watt Brushless Hub Motor
• Battery: 5pcs 12v20ah battery
• Max weight capacity: 280lbs
• Brakes: rear left and right
• Rated speed: 22-25 MPH(weight dependant)
• Range per charge: 18-24 miles(weight dependent)
• Scooter Dimensions: 6531.545 inches
• Front-wheel diameter: 22inch air-filled tires
• Rear tire diameter: 18-inch air-filled tires.

IMPORTANT!
BEFORE YOU OPERATE YOUR ELECTRIC SCOOTER PLEASE READ CAREFULLY: YOUR EXISTING INSURANCE POLICY MAY NOT PROVIDE COVERAGE FOR ELECTRIC VEHICLES; YOU SHOULD CONTACT YOUR INSURANCE AGENT TO
DETERMINE IF COVERAGE IS PROVIDED.

• Do not ride this scooter until you read and thoroughly understand the owner’s manual. If you have questions about the operation of this scooter, you should contat our service department.
• You must follow the safety guidelines contained in this manual to ensure maximum safety.
• Failure to comply with the standards outlined in this manual could result in fire and/or/serious injury.
• We are not liable for any damage or injuries caused by unsafe or faulty repairs. Any repairs made to this product by unauthorized service technicians are the sole responsibility of the owner.

WARNING
PLEASE MAKE SURE THE QUICK RELEASE HAS BEEN LOCKED BEFORE DRIVING. HANDLEBARS ASSEMBLE MUST OVER THE SAFETY VALVE AND MAKE SURE HAS BEEN LOCKED. CHECK IF ALL TIRES ARE PROPERLY INFLATED BEFORE RIDING THE SCOOTER. ALWAYS WEAR A HELMET WHEN RIDING THE SCOOTER. WEAR REFLECTIVE CLOTHING. NEVER TRY STUNTS. ALWAYS MAINTAIN A SAFE SPEED.

FOLLOW ALL STANTE &CITY LAWS REGARDING THE USE OF ELECTRIC SCOOTERS ON ROADS.
Our products are designed to be ecologically Conscious, please dispose of used batteries in Compliance with local laws.

WARNING
THE ELECTRIC TRI SCOOTER IS NOT A TOY AND SHOULD NOT BE OPERATED BY ANYONE UNDER 16 YEARS OLD.

Safety Instruction(Please take note of the following before each Ride.)

• The maximum weight capacity is 300 lbs.
• Only one person at a time should ride.
• Always wear protective gear including knee and elbow pads and an approved safety helmet when riding the scooter.
• Before riding be sure to check that all pivot points, locking buttons, quick releases, and latches are secured properly.
• The power switch lock must be in the “off” position when the tri-scooter is being charged.
• Do not use the scooter when it is raining.
• Do not place the battery near heat or fire.
• Do not expose the charger near the water.
• Check if battery after each use.
• Always ride on dry paved surfaces. Wet and uneven surfaces are a hazard.
• Send and lose impediments are your enemy, avoid them.
• Never operate too fast for your skills or condition.

Fast Installation

1. Fix the front wheel.
2. Handlebar. Inset the handlebar and bolt, then screw it.
3. Fix the seat first, and inset with the bike, then screw.

To ride, plug the ket into the ket ignition and turn the key to the “ON” position. The battery gauge will illuminate indicating that the battery is in operation. Hold onto the handlebars with both hands. Your left fingers will control the brakes and your right thumb will control the thumb throttle. As you depress the throttle lever with your thumb the speed will increase. Release the thumb throttle and apply the brake to stop the scooter. You will control the speed of the scooter by using both the throttle and the brake. When the brake handle is squeezed it cuts power to the throttle.
NOTE 1: You may use the balancing wheel(the smaller rear wheel) to balance the scooter when you want to ride with the front wheel raised.

WARNING: Never try stunts beyond the control of your skills. Never ride too fast for your skills or condition.
NOTE 2 When the scooter is parked, press the power switch button, on the “OFF” position; this will prevent anyone from accidentally pushing the throttle and causing the scooter to speed forward, Failure to do this could lead to an accident.

FOLDING THE TRI SCOOTER

1. Unplug the power connecting plugs.
2. Unscrew the bolts and nuts from the connecting tube clamp using the enclosed allen wrenches.
3. Life the connecting tube(which is also attached to the handlebar tube).
4. Carefully place the handlebar tube on the footrest frame.
5. Finger screw the bolts and nuts back to the connecting tube clamp to avoid any misplacement.

MAINTENANCE

Battery:(for professional use only)
The scooter is powered by 60V20AH rechargeable batteries secured in a battery bag. Other than recharging, these batteries need no maintenance. To prolong battery life, you must recharge the battery after each use. You must also charge your scooter if it has not been used for 30 days or more. If you must replace the batteries, they are located at the battery compartment at the footboard. To get them, remove the batteries with new ones, and reconnect the wires. Follow the instructions on charging batteries to charge the new batteries.

TROUBLESHOOTING GUIDE

(for professional use only)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>