Intertek P1903-66A-L George Kovacs LED Pendants Fixtures Installation Guide

Intertek P1903-66A-L George Kovacs LED Pendants Fixtures

Product Specifications

• Item Number: P1903-66A-L
• Revision Date: 11/10/2023
• Dimmable with ELV and/or LED-compatible wall dimmer switch

Product Usage Instructions

Preparation:

1. Carefully remove the fixture from the carton and ensure all parts are included.
2. Turn off the power at the circuit breaker and remove the old fixture along with the mounting hardware.

Connecting the Wires:

• Connect the electrical wires according to the provided diagram (Fig. 2). Ensure all wire connectors are securely fastened. Connect the fixture’s ground wire to either the outlet box ground wire or directly to the mounting plate using the green screw.
• Once the wires are connected, neatly tuck them inside the outlet box.

Finishing the Installation:

• Attach the canopy (D) to the mounting plate (B) and secure it with the mounting plate screws (E).
• Your installation is now complete. Restore power to the outlet box and test the fixture.

Frequently Asked Questions

• Q: Can this fixture be dimmed?
  • A: Yes, this fixture is dimmable with ELV and/or LED-compatible wall dimmer switches.
• Q: Is it necessary to hire a qualified electrician for installation?
  • A: It is highly recommended to have the fixture installed by a qualified electrician to ensure proper wiring and installation.

WARNING! SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

PREPARATION

1. Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.

2. Shut off power at the circuit breaker and remove the old fixture including the mounting hardware.
   MOUNTING THE FIXTURE (FIG. 1)

3. To retract wire, gently push it into light fixture base. To extend wire, push the metal collar while gently pulling wire down. When the metal collar is released, the wire will be fixed into position. Now turn fixture over and slide plastic wire retainer up to hex nut of canopy, as a secondary safety precaution to prevent fixture from slipping down when in use.

4. Loosen mounting plate screws (E) to remove mounting plate (B) from canopy (D).

5. Attach mounting plate (B) to outlet box (Not included) using outlet box screws (C) (Size: #8-32N*L1”L) as shown in Fig.1. Make sure side of mounting plate marked ”GND” must face out.
   CONNECTING THE WIRES (FIG. 2)

6. Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to mounting plate (B) using the green screw provided.

7. After wires are connected, carefully tuck them inside the outlet box.
   FINISHING THE INSTALLATION (Fig.1)

8. Mount canopy (D) onto a mounting plate (B) and secure it with mounting plate screws (E). Your installation is now complete. Return power to the outlet box and test the fixture.

Note: The illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased. Dimmable with ELV and/or LED compatible wall dimmer switch.

IMPORTANT: THE FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPERWIRING AND INSTALLATION.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>