solaredge LTE Modem for 1ph and 3ph Inverters Instruction Manual

solaredge LTE Modem for 1ph and 3ph Inverters Instruction Manual

Assembly Instruction

Route the antenna cable along the inner fins or the inverter side, in the bracket. Make sure the cable is not hanging loose outside the inverter enclosure

Open the gland numbered 1 at the bottom of the inverter.

Remove the rubber seal from the gland and insert the cable through the gland body and the opened connection of the inverter.

Push the cable into the cut opening of the rubber seal.

Insert the rubber seal with the cable into the gland body and reconnect the gland to the inverter. Tighten the sealing gland.

Pull the excess cable into the inverter so that the cable can be attached to the inverter communication board (see Figure 13). The cable connects to theGSM modem as described in the next section.

1. If there is no SIM card installed in the modem, insert one into the slot on the GSM modem.

2. Remove the inverter cover as described in its manual

3. Loosen the upper-right screw attaching the communication board to the standoff.

4. Attach the supplied holder to the communication board and use the removed screw to fasten the holder to the board.

5. Locate the modem in its place on the communication board, as shown in Figure 12. Follow these guidelines:

   • Use the supplied holder to position the modem with the correct orientation and stabilize it
   • Plug in the modem making sure that all pins are correctly positioned in the modem connector, and no pins are left out of the connector.
   • Make sure that the modem is firmly in place.

6. Connect the antenna cable to the cellular modem and tighten manually (see Figure 13).

7. Install the cable holder at the side of the communication board

8. Turn the AC ON.

9. Check that alltheGSM modem LEDs are lit. If not, refer to Troubleshooting on page 21.

7R,QVWDOOWKHPRGHPLQWKH6

1. Locate the modem in its place on the communication board. Make sure that the modem is firmly in place (see Figure 15).

2. Connect the antenna cable to the modem and tighten manually.

3. Use the tie-wrap to fasten the modem to the communication board.

4. Verify that the ON/OFF switch and Safety Switch (if installed) are OFF.

5. Turn the AC ON.

Check that all the GSM modem LEDs are lit (see Figure 14). If not, refer to .6 Troubleshooting on page 21.

Configuring GSM Communication

This chapter describes how to activate the GSM modem (if using a non solarEdge SIM card), configure the inverter to use GSM communication, verify the connection and troubleshoot problems.

1. Verify that the inverter ON/OFF switch is OFF.

2. Enter the inverter Setup mode:

3. SolarEdge 1Ph/3Ph inverters – Press the Enter button for 5-10 seconds and release. Enter the password 12312312.

4. SolarEdgeHD-Wave inverter – Press the OK button for 5-10 seconds and release. Enter the password 12312312 (Up=1, Down=2, OK=3:
   Up Down OK Up Down OK Up Down).

5. Scroll down to the Communication sub-menu and press Enter to select it. The Communication menu is displayed (Some of the menu items may vary depending on configuration).

6. Select Server / Cellular

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>