TWOPAGES Roman Shade Instruction Manual
- August 6, 2024
- TWOPAGES
Table of Contents
TWOPAGES Roman Shade
STUCK ON MEASUREMENTS?
WE’RE HERE TO ASSIST WITH YOUR MEASURING NEEDS!
Contact Us:
Support@twopagescurtains.com
+ l 866-220-2391 (9:00-18:00 EST)
HOW TO MEASURE ROMAN SHADES
Choose a Mount Type: Inside Mount or Outside Mount
INSIDE MOUNT
- Shades are installed inside the window casing
- 2 ½” minimum depth is required to do an inside mount
- Provides a clean. built-in look
- ¾”deduction in width is needed to ensure proper operating clearance
Step l: Measure the depth
Measure the depth at the top of the inside window casing to ensure adequate
space for a secure inside mount. This measurement will also determine if a
flush mount. where the product sits within the window frame without
protruding. is possible. A minimum depth of 2 ½” is necessary for an inside
mount.
Step 2: Measure the width
Due to potential irregularities in window shapes. it is recommended to measure
the window at three places: across the top. middle. and bottom. Round each
measurement down to the nearest 1/s”.
To ensure the shade fits correctly, Take the smallest of these measurements
and deduct¾” to get the final measurement of width.
Step 3: Measure the length
To determine the length. also measure the window in three locations: across
the left. center. and right. Round each measurement up to the nearest 1/s”.
Use the largest of these measurements as your ordering length.
OUTSIDE MOUNT
- Shades are mounted outside the window casing
- Mount directly on the wall or to the window frame. no depth requirements
- Provides better privacy
Step l: Measure the width
Measure the width of the area you want to cover. If space permits. it is
recommended to add 2-4 inches (l -2 inches on each side) to this measurement
to reduce light seepage. This adjusted measurement will be your ordering
width. representing the overall width of the shade.
Step 2: Measure the length
Measure the height of the area you intend to cover. This measurement will be
your ordering length.
FURTHER ASSISTANCE: Apply Measurement Finder Tools at Support Section in
twopagescurtains.com
NOTE: The dimensions obtained after using the Measurement Finder Tool are
the result with¾ inch already subtracted.
TWOPAGES
https://twopagescurtains.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>