LIVINOX LGH-428 2B-SS Stainless Steel Gas Hob Instruction Manual
- August 5, 2024
- LIVINOX
Table of Contents
LIVINOX LGH-428 2B-SS Stainless Steel Gas Hob
Dear Consumer,
Thank you for your purchase of our products. To ensure you use the appliance
in the best effect, please read this instruction manual with care before using
and save it for future reference. The manufacturer declines all responsibility
for damage to persons or things caused by non-observance of the above
prescriptions or by interference with any part of the appliance or by the use
of non-original spares.
Special Precautions
To avoid any danger and loss when using the hob, we make below mark. Below is all about special precautions. Please pay full attention to it and operate in a right way. Marks are identified by different danger and loss level
- WARNING : fignoring this mark and operate unproperly, it may lead die, hurt or fire.
- ATTENTION : If ignoring this mark and operate unproperly, it may lead die, hurt or fire.
- ADVICE : In order to be safe and convenient when using it, please kindly understand this content.
ATTENTION
- There should be space of at least 400mm height between the hob bottom and cupboard. And the space can not be sealed, with hole of diameter not less than 0.2 sq meter.
- Gas container can not be put right below the hob. Gas pipe not more than 2 meters.
- To ensure the burner and trivet are put in the right place before using the hob. the wall, Imm from above)
- Keep the kitchen in ventilated situation.
- But do not let strong wind to below the burner directly.
- Do not touch the trivet and burner immediately after using it, because they’re very hot gas brake when you go out or go to sleep.
Parts Identification
Remark: Above is the built-in hob structure and part identification. Other type of hob can refer to above picture.
Installation
-
Open holes in the cupboard:
Open holes in the cupboard with the instruction paper in the package. (see picture 3) -
Install the gas pipe
- A. If to use plastic tube: put in the airproof caution, connect the tube and hob connector, fasten the clip. (see picture 4)
- B. If to use metal tube: put in the airproof caution, fasten the nuts on the connection. (See picture 5)
-
Put the hob in the right hole on the cupboard, check whether it’s installed in a balance. The bottom of top plate should be stuck with seal packing.
-
Check leakage: turn on the gas valve. check whether with soap water there’s leakage in the connection. If any leakage, it needs to be reinstalled. (there’ll be air bubble for leakage).
Direct for Use
Ignition safety hob have flame failure protect device. When accident flame failure occurs by wind or spilled liquid, the flame failure protect device will shut the gas supply automatically.
- Insert battery properly into battery case located at bottom of hob.
- Turn on the gas valve.
- Turn the knob left until it reaches the full on position (about 90 degree anti-clockwise). Having heard the sound of continuous sparks, simultaneously the burner will be ignited. Keep pushing the knob for 5-8 seconds before taking your hand.
- You can choose five different fame by turning the hob.
- Turn the hob to OFF by clockwise. After continuous sound, the gas supply will be cut-off, and flame out.
NOTE :
- For the newly installed hob or hob not used for some time, it may fail to ignite at first time, because there’s air in the tube. You can repeat until the air is exhausted out, then it can work.
- If there’s yellowish flame or uneven flame, adjust the damper at the bottom to get a normal flame.
Product Dimensions
Cleaning and Maintenance
To ensure the hob can be used properly, the clearance and maintenance is necessary. Keep the hole of burner cap and gas flow not to be stuff. Keep the electrode and thermocouple clear. Before clearing and maintenance, shut off the gas supply and let all parts cold. Wash burner caps, burner, electrode, thermocouple and trivets with mild detergent when they’re dirty. Then put them back to their proper position. Use steel wire to clear the dirt in the burner cap. When the top plate get dirty, never use any sharp or hard brush but only sponge brush with mild detergent to clean them. To check the gas tube often, and change new gas tube for every two years.
Timer Operation
- Twist the knob to start the cooktop and the battery level display icon will light up. You can now press key to activate the timer setting for left burner, or press key to activate the timer setting for right burner. The digital screen will start flashing when selection is confirmed.
- When timer setting is activated, adjust the desired time by pressing key to increase time or pressing key to decrease time.
- You can set the timer up to maximum 180 minutes, left burner and right burner are set independently.
- If you wish to cancel timer function, long press key to turn off the left burner timer setting, while long press key to turn off the right burner timer setting.
- Timer setting will not activate when it detected on low battery condition, it can be clearly seen on battery level display indicator.
- If battery power detected low battery while timer function is operating, the alarm protection will activate automatically to shut off the burner.
- When battery power indicator alerted on low battery, replace with new battery immediately.
Self-test shut off function
Twist the knob to start cooktop, long press both & key , it will enter into
self-test shut-off program.
TROUBLE-SHOOTING
Remark : Trouble with mark ” “can be solved by final users. Trouble with “ ” must be repaired by technical people If final user can not solve problem according to above guide, call our after-sale service.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>