PHILIPS BGP307 ClearWay Gen 2 LED Lighting Installation Guide

: August 2, 2024
: Philips

Table of Contents

PHILIPS BGP307 ClearWay Gen 2 LED Lighting
Product Usage Instructions
Frequently Asked Questions
WHAT IS IN THE BOX
SPECIFICATION
Disconnect before servicing
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PHILIPS BGP307 ClearWay Gen 2 LED Lighting

Product Usage Instructions

Powering On

Check the green LED indicator to verify power connection.
Ensure that the luminaire is compatible with the SR components/sensors specified.

Component Compatibility

For SR-based luminaires, only SR-certified components/sensors should be used. Refer to the provided link for more information.

Maintenance

Regularly inspect the luminaire for any damage or wear and tear. Clean the surface as needed to maintain optimal performance.

Frequently Asked Questions

Q: What should I do if the luminaire is not turning on?

A: Check the power source, ensure proper installation, and verify component compatibility as per the manual instructions.

Q: Can I use a different power input than specified?

A: No, it is recommended to use the specified power input to prevent damage and ensure proper functionality.

WHAT IS IN THE BOX

SPECIFICATION

Installation

Ensure the power supply matches the required input voltage of the luminaire.
Mount the luminaire in a suitable outdoor location with proper support.
Make sure to follow the specified minimum distance requirements for installation.

To get an overview of all spare parts for a luminaire, please refer to detailed instructions in the service manual available via the Signify Service tag apps (Android and iOS). To program a spare driver is supported by Signify Service tag (Android only)

Disconnect before servicing

This product contains a light source of energy efficiency class: see table or label. Luminaire has basic insulation between Low Voltage supply and control conductors. Storage, installation, use, operation and maintenance of the products needs to be performed exactly according the instructions in this manual and/or other instructions as may be provided by us to guarantee safe use of the product over its entire lifetime. Failure to adhere to these instructions will invalidate your entitlement to warranty. Bolts with indication of torque strength on the drawing need to be tightened using a calibrated torque wrench. Preassembled bolts need to be retightened again to the required torque specification to assure maximum strength over lifetime. The light source and/or control gear and/or the external flexible cable contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person. The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 25cm is not expected. Zhaga-D4i and SR certified compatibility – For Zhaga-D4i/SR-Certified based luminaires only Zhaga-D4i/SR-Certified components/sensors are to be used (see also: https://www.zhagastandard.org/products / https://www.lighting.philips.co.uk /oem-emea/products/driving-connected-lighting). The functional compatibility of two SR-certified and/or Zhaga-D4i controllers/sensors to be used in combination, as well as the override possibility of any line-switch function used in an SR-based/Zhaga-D4i luminaire, is to be released by the master controller/sensor supplier. If using a NEMA 7-pin socket on an SR-based luminaire, a full system verification is required. Not following this advice can/will cause risk of damage and non-compliance for which Signify cannot take any responsibility.

© 2021 Signify Holding
All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner.
The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. No liability will be accepted by the publisher for any consequence of its use.
Publication thereof does not convey nor imply any license under patent- or other industrial or intellectual property rights.
Signify Holding
The Netherlands

4427 103 32397
© 22/01/2023, Philips Lighting Holding B.V. All rights reserved