Xtralite XL20717 Small LED Tap Light Instruction Manual
- July 31, 2024
- xtralite
Table of Contents
Xtralite XL20717 Small LED Tap Light Instruction Manual
Please read these instructions carefully before connecting or using the appliance. Keep for future reference.
EASY INSTALLATION:
Before first use, use the micro USB cable (included) to charge the product until the indicator light turns green.
Place the magnetic strip on the back of the unit with the adhesive strip face up.
Remove the sticker from the magnetic strip and place the light onto the desired surface. Hold firmly against surface for 30 seconds.
Tap the light to turn on.
EASY REMOVAL:
Simply pull the unit off the wall. To remount it just place it back to where you had it previously mounted.
SCREW FIXING:
Locate the sites for the screws by measuring the distance from the centre from one keyhole slot to the other.
Mark the locations to install the 2 screws. Carefully drive screws in, leaving a little over a 1/16″ gap.
Slide the product’s two keyhole slots over the two screw heads until both sides are captured by the narrow end of the keyhole slots.
SWITCH SETTINGS:
Switch Controls:
On : Light stays on continuously
3m : Light turns off after 3 minutes after being activated.
15m : Light turns off after 15 minutes after being activated.
Off : Light is off
IMPORTANT : Failure to follow instructions carefully may cause damage.
CAUTION : Do not hang over beds or on wallpaper. When disposing of,
please locate local recycling centre.
Dimensions: 97mm x 77mm x 20mm
Weight: 60g
LED quantity: 3
Lamp CCT: 4000K
Lumens: 50
Battery type: Rechargeable Li-ion 3.7V/1500mAH
Power Switch: Tap ON/OFF
Indoor use only
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>