Rehabmart Clamp Installation Examples Installation Guide
- July 31, 2024
- RehabMart
Table of Contents
Clamp Installation Examples
Installation Guide
Post Installation
STEP: 1
DO NOT CEMENT POSTS INTO PLACE UNTIL THE ENTIRE STRUCTURE IS ASSEMBLED.
Refer to the General Installation guide footing information and dig proper
holes for the support posts. 3.5-Inch Clamp Installation Examples
The following three pages will include examples of how to install some of the
most common types of Clamps that are present on our structures that use
3.5-Inch outside diameter posts. The structure that you are assembling might
not require all the types of clamps listed in these examples.
The Install Guides for specific components that come later in this document
might call for a specific type of clamp (a tube clamp for example), those
sections will not include detailed instructions for the clamps and should
direct you back to this section for more detailed information.
3.5-Inch Flat Clamp Install Example
Connect half of the flat clamp to the component using one (1) M840 bolt.
Then, using the other half of the flat clamp and the hardware provided in the
clamp hardware bag, attach the backside of the flat clamp around the post.
3.5-inch Clamp Installation Examples
3.5-Inch Tube Clamp Install Example
Connect half of the clamp to the component using one (1) M830 bolt. Then,
using the other half of the tube clamp and the hardware provided in the clamp
hardware bag, attach the backside of the tube clamp around the post.
3.5-Inch 90-Degree Flat Clamp Install Example
Connect half of the flat clamp to one panel using one (1) M8*40 bolt. Then,
using the other half of the flat clamp and the hardware provided in the clamp
hardware bag, attach the other half of the tube clamp around the post. Then,
attach the next panel to the other side of the clamp using the same process.
3.5-inch Clamp Installation Examples
3.5-Inch Double Slide Clamp Install Example
Connect half of the double slide clamp to the double slide hood using one (1)
M8*30 bolt. Then, using the other half of the clamp and the hardware provided
in the clamp hardware bag, attach the backside of the double slide clamp
around the post.
Tic Tac Toe Panel Installation
STEP: 1
Attach the Tic Tac Toe Panel to the designated posts using two (2) flat clamps
for the top of the panel, and two (2) tube clamps for the bottom of the panel.
10859 E Washington Street, Ste. 200
Indianapolis, IN 46229
Created By: Derick H
Date: 10/24/2018