JABLOTRON JA-152KRY Control Panel Owner’s Manual

: July 31, 2024
: JABLOTRON

Table of Contents

JABLOTRON JA-152KRY Control Panel
Product Information
FAQ
Introduction
Description
Technical Specifications
Contact
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JABLOTRON JA-152KRY Control Panel

Product Information

Description

The JA-152K control panel offers a variety of features including support for up to 31 wireless peripherals, up to 32 users, up to 4 sections, and up to 2 programmable PG outputs. The setup process is intuitive and simple, suitable for both experienced technicians and novice installers.

Installation Instructions

Installation of this product should be carried out by a trained technician with a valid certificate issued by an authorized Jablotron distributor.
The required settings and system parameters can be programmed via MyCOMPANY.

FAQ

Q: Can I install the control panel myself?
- A: No, installation should be done by a trained technician with a valid certificate.
Q: How many wireless peripherals can be connected?
- A: Up to 31 wireless peripherals can be connected to the control panel.
Q: What is the maximum battery backup duration?
- A: The back-up battery provides a maximum duration of 72 hours.

Introduction

JA-152KRY Control panel with radio module and 4G communicator LITE

Installation should be done by a trained technician with a valid certificate issued by an authorized Jablotron distributor.
The required settings and system parameters are programmed via MyCOMPANY. The setup is intuitive and very simple even for novice installers.

Description

The JA-152K control panel offers:

up to 31 wireless ○ peripherals
up to 32 users
up to 4 sections
up to 2 programmable PG outputs

Technical Specifications

Installation type Fixed installation
Control panel power supply ~ 110 – 230 V/50 – 60 Hz, max. 0.28 A with F1.6 A/250 V fuse, security grade II
Electrical power / current Max. 23 VA / 0.1 A
Protection class II.
Back-up battery 3.7V, 5000 mAh, Li-Polymer
Low battery backup voltage (fault indication) ≤3.5V
Maximum battery recharge time (80% capacity) 72 h
Maximum number of sections 4
Maximum number of devices 31 devices + 31 remote controllers
Maximum number of users 32
Max. number of PG outputs 2
Alarm connections Wireless connection– unspecified wireless connection, Jablotron wireless protocol
Classification of Alarm device Security Grade 2 / Environment Grade II
@ According to standards EN50131-1, EN 50131-3, EN 50131-6, EN 50131-5-3, EN 50131-10, EN 50136-1, EN 50136- 2
@ Environment Indoor general
@ operational temperature range / humidity range -10 °C to +40 °C / 75% RH without condensation
@ power supply Type A – primary mains power supply with a powered back-up battery.
@ event memory capacity approx. 7 million events, including sources and timestamps.
@ system reaction to loss of device communication Fault or Tamper – Dependent on selected profile
@ wireless communication within 2h (from last communication)
@ Wireless communication within 20min blocks section setting
@ system reaction to incorrect code entry Alarm after 10 wrong code entries, dependent on selected profile, the system will be locked for ten minutes.
@ ATS classification Supported ATS classes: SP2 – SP5,
- SPT: type Z
- Operation type: Pass-Through
- GSM2201MD SP3 – SP5 (JABLO IP, ANSI SIA, DC-09)
@ ATS Alarm transmission protocols JABLO IP
@ ATC security against substitution and protection of information Jablotron protocols: proprietary AES encryption with a minimally 128 bit key ANSI SIA DC- 09.2012 protocol with 128 bit AES encryption
Dimension 182 x 132 x 58 mm
Weight with battery / without battery 510 g/430 g
Based parameters of the JA 111R module 868.1 MHz, <25 mW, GFSK <80 kHz
Radio emissions ETSI EN 300 220-1,2
EMC EN 50130-4, EN 55032, ETSI EN 301 489-1, ETSI EN 301 489-3
Safety conformity EN IEC 62368-1
Conditions of operation ERC REC 70-03
Certification body TREZOR TEST (no. 3025)