Godox WES-C1 Wireless Lavalier Microphone System User Manual

Godox WES-C1 Wireless Lavalier Microphone System User Manual

Foreword

Thank you for purchasing!
WES-C1 is the charging case of Godox’s latest wireless lavalier microphone system for smartphones. It has three built-in slots, which can store three devices and charge two transmitters at the same time. Two indicators inside conveniently show charging status of the transmitters, while the number display outside clearly shows the battery level of itself.
Please read this manual carefully before using to make sure the correct operation and exert the optimum function.

Main Features

• Built-in three slots can store three devices at the same time.
• Built-in lithium battery can charge two transmitters at the same time.
• Two indicators inside show charging status of the transmitters.
• Number display outside shows the battery level of itself.
• Support charging through USB-C cable.

Warning
This product is high-precision instrument, please avoid falling, collision or pounding.
Do not disassemble. Should repairs become necessary, this product must be sent to our Company or an authorised maintenance center.
Always keep this product dry. Do not use in rain or damp conditions.
Do not leave or store this product in the environment of direct sunlight, near heating devices, or in hot, humid or dusty.
Keep out of reach of children.
Do not use in flammable and explosive environments. Pay attention to the relevant warning signs.
Do not leave or store the product if the ambient temperature reads over 50℃.
Please read carefully and follow the warnings or instructions provided by the manufacturer.

Structure of Product

1. Transmitter’s Slot
2. Receiver’s Slot
3. Indicator
4. Display
5. USB-C Charging Port
6. Reset Hole

What’s Inside

• Charging Case × 1

• USB-A to USB-C Data Cable × 1

• Instruction Manual × 1

Note:
Due to continuous updates and upgrades of the products, there may be differences between the actual products and the pictures. Therefore, the pictures are for reference only, products to prevail in kind.

Instructions for Use

Put the devices into the charging case and open the lid: The case will first detect whether the transmitters are correctly inserted into the corresponding slots, the corresponding indicators in the case will light up if the pins inside touched the charging points of the transmitters. Then it will detect whether the transmitters are fully charged, if not, it will start charging until the transmitters are fully charged. The indicators and number display will light up at the same time if the charging case lid is open, and turn off after the devices are fully charged in 5s.

Put the devices into the charging case and close the lid: The transmitters will shut down and be charged until they are fully charged. The number display will be off in 1min after closing the lid.

Charging the case itself: The number display will increase gradually from 0 to 100, and remain 100 after the charging case is fully charged.

devices
Indicators inside the charging case are constant on white| The devices are fully charged

Technical Data

Specifications and data may subject to changes without notice.

Maintenance

Avoid falling. Strong collision or vibration may malfunction the device.
Keep dry. This product is not water-proof. Malfunction, rust, and corrosion may occur and go beyond repair if soaked in water or exposed to high humidity.
Avoid sudden temperature changes. Condensation happens in sudden temperature changes such as the circumstance when taking the product out of a building with higher temperature to outside in winter. Please put the product in a handbag or plastic bag beforehand.
Keep away from strong magnetic field. The strong static or magnetic field produced by devices such as radio transmitters leads to malfunction.
Specifications and data may subject to changes without notice.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Declaration of Conformity

GODOX Photo Equipment Co.,Ltd. hereby declares that this equipment are in compliance with the essential requirements and other relevant provisions of Directive 2014/35/EU,2014/30/EU. They are allowed to be used in all EU member states. For more information of DoC, Please click this web link:
https://www.godox.com/eu-declaration-of-conformity

Warranty

Dear customers, as this warranty card is an important certificate to apply for our maintenance service, please fill in the following form in coordination with the seller and safe-keep it. Thank you!

Address
Seller Information| Name
Contact Number
Address
Date of Sale
Note

Note: This form shall be sealed by the seller.

Applicable Products

The document applies to the products listed on the Product Maintenance information (see below for further information). Other products or accessories (e.g. promotional items,giveaways and additional accessories attached,etc.) are not included in this warranty scope.

Warranty Period

The warranty period of products and accessories is implemented according to the relevant Product Maintenance Information. The warranty period is calculated from the day(purchase date) when the product is bought for the first time,and the purchase date is considered as the date registered on the warranty card when buying the product.

How to Get the Maintenance Service

If maintenance service is needed, you can directly contact the product distributor or authorised service institutions. You can also contact the Godox after-sale service call and we will offer you service. When applying for maintenance service, you should provide valid warranty card. If you cannot provide valid warranty card, we may offer you maintenance service once confirmed that the product or accessory is involved in the maintenance scope, but that shall not be considered as our obligation.

Inapplicable Cases

The guarantee and service offered by this document are not applicable in the following cases:

1. The product or accessory has expired its warranty period;
2. Breakage or damage caused by inappropriate usage, maintenance or preservation, such as improper packing, improper usage, improper plugging in/out external equipment, falling off or squeezing by external force, contacting or exposing to the improper temperature, solvent, acid, base, flooding and damp environments, etc;
3. Breakage or damage caused by non-authorised institution or staff in the process of installation, maintenance, alternation, addition and detachment;
4. The original identifying information of product or accessory is modified, alternated, or removed;
5. No valid warranty card;
6. Breakage or damage caused by using illegally authorised, nonstandard or non-public released software;
7. Breakage or damage caused by force mature or accident;
8. Breakage or damage that could not be attributed to the product itself. Once met these situations above, you should seek solutions from the related responsible parties and Godox assumes no responsibility. The damage caused by parts, accessories and software that beyond the warranty period or scope is not included in our maintenance scope. The normal discoloration, abrasion and consumption are not the breakage within the maintenance scope.

Maintenance and Service Support Information

The warranty period and service types of products are implemented according to the following Product Maintenance Information:

Product Type| Name| Maintenance Period(month)| Warranty Service Type
---|---|---|---
Pafis| Product Main Body| 12| Customer sends the product to designated site
Battery| 3| Customer sends the product to designated site
Charger, Electrical Pafis etc.| 12| Customer sends the product to designated site
Other Items| Battery Case, Windscreen Foam, Wind Cap, Locking Device, Lanyard, Tie, Velcro Tape,Clip, Bag, Package etc.| No| Without warranty

Godox After-sale Service Call 0755-29609320-8062

Godox Audio We chat Official Account

Overseas Official Accounts & Updates

GODOX Photo Equipment Co., Ltd.
Add.: Building 2,Sichuan Industrial Zone, Tangerine Community, Haifa Street, Baobab District, Shenzhen 518103, China
Tel : +86-755-29609320(8062)
Fax: +86-755-25723423
E-mail : godox@godox.com

www.godox.com
Made in China 705-WESC10-00

References

• GODOX Photo Equipment Co.,Ltd.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>