FAGERHULT VTB Multilume Slim Instruction Manual

Table of Contents

Connection and Installation

Before plugging in the mains voltage, ensure that the luminaire is connected properly. Basic insulation between mains and control wiring is essential for safe operation.

Replacement

The light source, control gear, and external cable should only be replaced by the manufacturer or their designated personnel.

Mounting

For optimal performance, install the luminaire in ventilated or unventilated spaces. Avoid covering the luminaire with insulating material to prevent overheating.

Maintenance

It is important to pass on all relevant information regarding installation and usage to users. Regular maintenance and inspections are recommended to ensure safe operation.

Frequently Asked Questions (FAQ):

Q: Can I replace the light source or control gear myself?

A: No, the light source, control gear, and external cable should only be replaced by the manufacturer or their designated personnel to maintain safety and warranty.

Q: Can I cover the luminaire with insulating material?

A: It is advised not to cover the luminaire with insulating material as it may lead to overheating. Always refer to the manufacturer’s guidelines for proper installation.

Q: Where can I find the manufacturer’s contact information?

A: The luminaire is manufactured by Fagerhult Sweden. For UK market inquiries, contact Fagerhult UK at 33-34 Dolben Street, London, SE1 OUQ.

Multilume Slim VTB

Multilume Slim Organic Response

Multilume Slim HB

Multilume Slim TW & Organic Response VTB

The product contains electronics that may be sensitive to electrostatic discharges (ESD) as well as mechanical stress.
To avoid damage, any open circuit board like LED modules should never be directly touched by hand or by a tool.
This is valid both during installation and normal maintenance.
A Pro lights mares with this replaced by the manufacturer or his designated person.

Products with an external driver

Some luminaires are for use with an external LED driver. If any other driver than standard is intended to be used it must be adapted for the luminaire.
It should be with corresponding functionality (constant current resp. constant voltage) and electrical parameters.

Insulation test

To avoid damaging the electronic ballast or other sensitive electronic devices, the phase and neutral must be connected before any insulation test (max 500V DC).
Automatic circuit breakers (MCB) and Residual current device (RCD)
Due to the high peak connection current MCB:s type C is recommended.
Peak-current-proof RCDs:s adapted for electronics are recommended. Normally a luminaire has a leakage current of 1 mA.

Luminaires for dimming

An amplifier may be required for long cable lengths or a large number of luminaires.
Digital technology permits cable lengths up to 250 meters.
Basic insulation between mains and control wiring.
Control voltage cables may be routed with mains cables if they are mains voltage insulated.
National regulations should be adopted. Control voltage cables for 1-10V are polarised (+/-) and must be connected correctly to all luminaires.
If pulse switching via a momentary push button is used, the connected luminaires must due to functional reasons be equipped with DALI drivers of the same brand!

No light? Check the supply voltage. Measure the voltage at the terminal in the luminaire.
For spotlights with track adapter: please check the positioning of the phase selector and the fixation to the track system.
According to REACH (EC 1907/2006) we are obliged to inform you that this product may contain a low concentration of Lead (Pb) CAS 7439-92-1.
Normal instructions for safe use apply, lead does not cause harm as it is incorporated in the chemical composition of the product and is not released in normal use.
Please contact reach@fagerhult.se for more information.
It is appropriate to give this information to the user of the installation.