LANDMANN 28905 Super Sky Fire Pit Instruction Manual

: July 30, 2024
: LANDMANN

Table of Contents

Important Information
PARTS LIST
HELPFUL HINTS
SAND PAINT FINISH:
SUPER SKY ACCESSORIES
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LANDMANN 28905 Super Sky Fire Pit

LANDMANN 28905 Super Sky Fire Pit

This Owner’s Manual is provided and hosted by Appliance Factory Parts.

Important Information

PLEASE READ ALL RULES FOR SAFE OPERATION BEFORE ASSEMBLY AND HELPFUL HINTS BEFORE USE.

Assembly and Use 28905
Instructions for Models: 28908

READ FIRST! RULES FOR SAFE OPERATION

FOR OUTDOOR USE ONLY!
USE ONLY ON BRICK, CONCRETE, STONE OR OTHER MASONRY SURFACES!
DO NOT USE ON LAWNS, WOODEN DECKS OR ASPHALT!
KEEP SUPER SKY AWAY FROM BUILDINGS, FLAMMABLE ITEMS AND VEHICLES.
THE SUPER SKY FIRE PIT IS FOR ADULT USE ONLY.
DO NOT LEAVE UNATTENDED AT ANY TIME WHILE IN USE.
KEEP SPARK GUARD ON SUPER SKY WHILE IN USE.
DO NOT USE IN WINDY CONDITIONS!
DO NOT OVERLOAD OR USE FOR BURNING GARBAGE.
NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START FIRES.
NEVER USE UNDER LOW HANGING TREE BRANCHES, TRELLIS, OVERHANGS OF ANY KIND INCLUDING COVERED PORCHES.
USE CAUTION WHEN TENDING THE FIRE, AS SURFACES WILL BE HOT WHILE IN USE.
BEFORE EACH USE MAKE SURE SUPER SKY IS IN GOOD WORKING CONDITION.
USE CAUTION AFTER THE FIRE HAS BEEN EXTINGUISHED, SURFACES WILL REMAIN HOT FOR SOME TIME.

Congratulations on your purchase of the Super Sky Fire Pit! At Landmann USA, we strive to provide you with an easy to use, easy to assemble product. However, in the unlikely event your package should have a missing or defective part, please contact us at: customerservice@landmann- usa.com

PARTS LIST

When unpacking the Super Sky from the carton, make sure you find and become familiar with all the pieces listed below:

(1) SPARK GUARD
(1) FIRE PIT
(3) LEGS
(3) SPARK GUARD PINS
(6) M8 NUTS
(6) M8 FLAT WASHERS
(1) EYEBOLT
(1) INSIDE WASHER
(1) MULTI-PURPOSE POKER
(9) 20MM BOLTS
(9) M6 NUTS
(8) M6 FLAT WASHERS

STEP 1
Take each of the (3) legs and bolt them to the fire pit (as shown in the diagram to the left) using (6) M8 flat washers and (6) M8 nuts. Tighten securely!
Assembly Instructions:

STEP 2
Assemble (1) ring section to the fire pit using (2) 20MM bolts, (2) M6 flat washers and (2) M6 nuts. Only finger tighten at this time.
Assembly Instructions:

STEP 3
Repeat STEP 2 for the remaining (3) ring sections. Make sure the (4) ring sections fit together to form a continuous ring. Tighten all bolts securely!
Assembly Instructions:

STEP 4
Take each of the (3) spark guard pins and thread them into the nuts welded on the inside of the fire pit. Do not over tighten!
Assembly Instructions:

STEP 5
Assemble the eyebolt as shown to the spark guard using (1) 20MM bolt, (1) inside washer and (1) M6 nut. Tighten securely. Place spark guard on the spark guard pins. The spark guard purpose is to keep sparks contained in the fire pit. PLEASE USE at all times.
Assembly Instructions:
STEP 6
IMPORTANT! Before using you must place 10-15 lbs of sand on the bottom of the fire pit. The sand insulates the area below the pit and protects against the corrosive nature of the ashes.

MULTI-PURPOSE POKER
The poker can be used not only for shifting and tending the fire, but also for lifting off the spark guard or pulling Super Sky to another location.

HELPFUL HINTS

ADDING SAND TO THE BOTTOM OF SUPER SKY HELPS PROTECT AGAINST THE CORROSIVE NATURE OF THE ASHES AND WILL EXTEND THE LIFE OF THE PIT.
BURN YOUR SUPER SKY 3 TIMES BEFORE USING TO COOK ON.
IF YOU ARE NOT GOING TO USE SUPER SKY FOR A LONG PERIOD OF TIME, STORE AWAY OUT OF THE WEATHER AND ELEMENTS.
DO NOT LET YOUR SUPER SKY FILL WITH WATER.
DO NOT DUMP ASHES WHERE THEY COULD START A FIRE.
DISPOSE OF ASHES IN PROPER RECEPTACLE ONLY AFTER ASHES HAVE COOLED.

SAND PAINT FINISH:

Note: Since the heat intensity from the fires will vary depending on the type and amount of fuel used, you may experience minimal peeling or flaking of the paint. This is normal and will not affect the safety or performance of the Super Sky Fire Pit.

SUPER SKY ACCESSORIES

These custom made accessories are made just for the Super Sky Fire Pit.| PRICE| QTY| EXTENDED EXTENDED
---|---|---|---
COVER TAPA
This high quality cover keeps out the elements.| $39.99 EACH| x| =
SHIPPING & HANDLING
For each cover| $15.00 EACH| x| =
HEAVY-DUTY GRATE
Sturdy 37″ dia. cooking grate made from heavy-duty expanded metal. Comes with handles for easy removal from the fire pit.| $69.99 EACH| x| =
SHIPPING & HANDLING
For heavy-duty grate| $31.00 EACH| x| =
TOTAL
Must include shipping & handling for each item bought.
NOTE: THESE PRICES ARE GOOD THRU DECEMBER 31, 2008

CUSTOMER SUPPORT

Shop genuine replacement parts for Landmann 28905
Find Your Landmann Grill Parts – Select From 200 Models

1-800-321-3473 M-F 8-5 Eastern Time
Proof of purchase may be required. Thank you!
Landmann USA
Cartersville, GA 30120
www.landmann-usa.com
Made in China
© 2007 Landmann USA