LANDMANN 23874 Fire Pit Owner’s Manual

: July 29, 2024
: LANDMANN

Table of Contents

Assembly and Use
PARTS LIST
FIRE PIT ASSEMBLY INSTRUCTIONS
COOKING GRATE
HELPFUL HINTS
COVER
Instruction For Use
Customer Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LANDMANN 23874 Fire Pit

LANDMANN 23874 Fire Pit

PLEASE READ ALL RULES FOR SAFE OPERATION AND HELPFUL HINTS BEFORE USING.

Assembly and Use

Instructions for Model:
23870
23871
23872
23873
23874
23875

READ FIRST!
RULES FOR THE FIREDANCE BEARS FIRE PIT SAFE OPERATION.

THIS OUTDOOR FIRE PIT IS FOR OUTDOOR USE ONLY!
USE ONLY ON BRICK, CONCRETE, STONE OR OTHER MASONRY SURFACES!
DO NOT USE ON LAWNS, WOODEN DECKS OR ASPHALT!
KEEP THE OUTDOOR FIRE PIT A MINIMUM OF 10 FT. AWAY FROM BUILDINGS, STRUCTURES, ANY FLAMMABLE ITEMS AND VEHICLES.
NEVER USE UNDER LOW HANGING TREE BRANCHES, TRELLIS, OVERHANGS OF ANY KIND INCLUDING COVERED PORCHES.
WARNING! NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START OR RESTART FIRES.
FOR LONGER PRODUCT LIFE, KEEP FIRES TO A RESPECTABLE SIZE, DO NOT OVERLOAD.
THE OUTDOOR FIRE PIT IS FOR ADULT USE ONLY.
DO NOT LEAVE UNATTENDED AT ANY TIME WHILE IN USE.
DO NOT MOVE THE FIRE PIT DURING USE.
DO NOT USE IN WINDY CONDITIONS!
DO NOT OVERLOAD OR USE FOR BURNING GARBAGE.
USE CAUTION WHEN TENDING THE FIRE, AS SURFACES WILL BECOME VERY HOT WHILE IN USE.
USE MITTENS OR GLOVES WITH THE POKER TO REMOVE THE SPARK GUARD, THE SPARK GUARD WILL BECOME VERY HOT!!
USE CAUTION WHEN REMOVING THE SPARK GUARD, AS HOT STEAM OR A FLARE UP COULD CAUSE BURNS.
BEFORE EACH USE MAKE SURE THE OUTDOOR FIRE PIT IS IN GOOD WORKING CONDITION.
USE CAUTION AFTER THE FIRE HAS BEEN EXTINGUISHED, SURFACES WILL REMAIN HOT FOR SOME TIME.
THE OUTDOOR FIRE PIT MUST BE COMPLETELY COOLED OFF AND ALL EMBERS MUST BE EXTINGUISHED BEFORE ANY COVER CAN BE USED.

PARTS LIST

When unpacking the fire pit from the carton, make sure you find and become familiar with all the parts listed below. Use caution as some parts may have sharp edges.

(1) SPARK GUARD
(1) COOKING GRATE
(1) FIREBOWL
(3) RING SECTIONS
(3) PINS
(6) M6 x 25MM BOLTS (BOLTS ARE PRE-ASSEMBLED TO RING)
(4) LEGS
(1) MULTIPURPOSE POKER
(8) M6 x 10MM BOLTS
(8) M6 FLANGE HEXNUT

FIRE PIT ASSEMBLY INSTRUCTIONS

A Phillips or plain screwdriver and an adjustable wrench are needed for assembly
Assembly time: 15 minutes

STEP 1: ASSEMBLE THE LEGS
Take each of the (4) legs [ EE ] and assemble them to the firebowl [ C ] as shown using (8) 10MM bolts [ X ] and (8) hexnuts [ Z ]. Tighten securely with adjustable wrench.
STEP 2: ASSEMBLE RING SECTIONS
Assemble (1) ring section [ DD ] to the firebowl [ C ] using (2) 25MM bolts [ J ]. For each ring section, assemble (1) pin [ M ] as shown between the bolt and the firebowl. Assemble the remaining (2) ring sections the same way. Be sure the pins are evenly spaced. Hand tighten the bolts only until all ring sections are assembled, then tighten all bolts securely.
STEP 3: PLACE SPARK GUARD
Place the spark guard [ A ] onto the pins [ M ].The spark guard keeps sparks contained in the fire pit. PLEASE USE at all times.
STEP 4: ADD SAND
Before using, add a 1-1.5 in. layer of sand or about 5 lbs. (size wise, its the same amount as a 5 lb. bag of sugar) to the bottom of the firebowl. This will help against the corrosive nature of the ashes and help radiate the heat upwards.

COOKING GRATE

Remove spark guard from the fire pit. Align and place the cooking grate [ B ] onto the (3) pins[ M ]. The pins will keep the cooking grate in position. Never burn wood on the cooking grate.

IMPORTANT! ADD 5 LBS OF SAND TO THE BOTTOM OF THE FIREBOWL.

WARNING!
CARBON MONOXIDE HAZARD!
BURNING WOOD OR CHARCOAL PRODUCES CARBON MONOXIDE, WHICH HAS NO ODOR AND CAN CAUSE DEATH IF BURNED IN ENCLOSED AREAS. NEVER BURN WOOD OR CHARCOAL INSIDE HOMES, VEHICLES, TENTS OR ANY OTHER ENCLOSED AREAS.

HELPFUL HINTS

ADDING 5 LBS OF SAND TO THE BOTTOM OF THE FIREBOWL WILL EXTEND THE FIREBOWL LIFE.
KEEP THE FIRE PIT OUT OF THE WEATHER AND ELEMENTS.
STORE THE FIRE PIT IN A DRY LOCATION OUT OF THE WEATHER.
DO NOT LET THE FIREBOWL FILL WITH WATER.
DO NOT DUMP ASHES WHERE A FIRE CAN BE STARTED.
DISPOSE OF ASHES IN PROPER RECEPTACLE ONLY AFTER ASHES HAVE COOLED.
USE ANY COVER ONLY AFTER THE FIRE PIT IS COMPLETELY COOL TO THE TOUCH.

Congratulations on your purchase of the Firedance Bears Fire Pit! At Landmann USA, we strive to provide you with an easy to use, easy to assemble product. However, in the unlikely event your package should have a missing or defective part, please contact us at:
customerservice@landmann-usa.com
-OR1-800-321-3473 M-F 8-5 ET. Proof of purchase may be required. Thank you!

AVAILABLE ACCESSORIES FOR THE FIREDANCE BEARS

DISPONIBLE ACCESSORIOS PARA FIREDANCE BEARS

These custom made accessories are made just for the Firedance Bears fire pit.

COVER

MODEL 29481

Cover

Please visit our website at: www.landmann-usa.com
-OR
Call customer service toll free at: 1-800-321-3473
Por favor, visite nuestro sitio web en: www.landmann-usa.com

Instruction For Use

Instruction For Use
HOT SURFACES DURING USE!

WARNING
NEVER USE GASOLINE, ALCOHOL OR VOLATILE FLUIDS TO START OR RESTART FIRES.

WARNING
HOT SURFACES DURING USE! USE MITTENS, POKER OR GLOVES ON THESE PARTS

Customer Support

Shop genuine replacement parts for Landmann 23874
Find Your Landmann Fireplace Parts – Select From 49 Models

Landmann® Limited
Distributed by Landmann® USA
Distribuído por Landmann® USA
Cartersville, GA 30120
www.landmann-usa.com
Made in China
Hecho en China
© 2012 Landmann® USA

Logo