AMEWI BUZZARD PRO XL V2 Just Remote Controlled Helicopter User Manual

JUST REMOTE-CONTROLLED
BUZZARD PRO XL V2
25190
OPERATION MANUAL

BUZZARD PRO XL V2 Just Remote Controlled Helicopter

Welcome to AMEWI
The Amewi Trade GmbH is an international import- and wholesale company for R/C models, toys and creative items, located in Borchen near Paderborn, Germany. Our product range includes over 10,000 items. Above all, this includes remote- controlled car, helicopter, boat, and tank models as well as a wide range of accessories and all necessary spare parts. Our sales network includes over 700 specialist dealer and online retailers across Europe.
The company AMEWI Trade GmbH is a pure wholesale company. We only sell our products to retailers. When you purchase AMEWI products as an end consumer, you are entering into a contract with the retailer. Please always contact your dealer in warranty cases.

AMEWI Trade GmbH
Nikolaus-Otto-Str. 18
33178 Borchen
Germany
Servicezeiten: Dienstag 9:30 – 12:00 Uhr | Donnerstag 14:00 – 16:30 Uhr
Telefon: +49 180 5009821 (Festnetz 14Ct/Min., Mobil max. 42Ct/Min.)
Support: https://amewi.com

DECLARATION OF CONFORMITY

This product has been manufactured according to actual technical standards. The product is matching the requirements of the existing European and national guidelines. The Declaration of Conformity has been proofed. AMEWI Trade GmbH declares that this product is matching the basic requirements and remaining regulations of the guideline 2014/53/EU {RED). The declarations and documents are stored at the manufacturer and can be requested and applied there. https://amewi.com/Konformitaetserklaerungen
For additional questions to the product and conformity please contact:
Amewi Trade GmbH Nikolaus-Otto-Str. 18, 33178 Borchen Germany or website https://amewi.com.

SECURITY AND HAZARD WARNINGS

For damage, caused by disregarding of the manual, warranty expires.
We are not liable for secondary failures, material, or personal damage, caused by in proper usage or disregarding the security notices.
Based on security and registration (CE) reasons, it is forbidden to modify the product personally. Do not disassemble the product.
Small parts. Danger of suffocation or risk of injury caused by small parts.
Suitable for people aged 16+!
The product is not allowed to get moist or wet. The product is only allowed to be used on flat and clean surfaces. Even a drop down from a small height can cause damage to the product.

BATTERY NOTICE & DISPOSAL

Attention! Battery do not belong in the hands of children. A change of the battery must be done by an adult person.
Never mix rechargeable batteries with non-rechargeable batteries. Never mix fully charged batteries with almost empty batteries. Never mix batteries of different capacities. Never try to charge dry batteries. Take care of the correct polarity.
Defective batteries belong to special waste. Never leave a charging battery unattended. For questions about the charging time please read the manual or ask the manufacturer.
Read the safety instructions and warnings before using or charging the Li-Ion battery.
Stop using or charging it immediately if it leaks, has a temperature above 70° C or anything else unusual occurs.
Use only a qualified and specific Li-Po/Li-Ion charger. Never charge the battery unattended. Do not charge the battery if the charge exceeds 4.2 V / cell. Do not charge the battery with a charging current above 2C. Please check and ensure that you are using a qualified charger. An unqualified charger may cause a fire.
Do not discharge the battery with a current exceeding the maximum discharge current. Otherwise, this will cause the battery to overheat. This may result in bursting, fire or explosion.
Never disassemble, puncture, knock, drop, short circuit and/or throw the battery into a fire.
Improper use such as short-circuiting, or overcharging may result in explosion or fire.
Keep the battery in a safe place that babies or children cannot reach.
The above indicates the danger of using the battery. The user assumes full responsibility for the outcome of using the battery.

DISPOSAL

AMEWI is registered below the Bat-Reg.-No. DE 77735153 and WEEE-Reg.-No. 93834722 at the foundation EAR and recycles all used electronic parts properly. Electric and electronical products are not allowed to put in household garbage. Please dispose the product at the end of the lifetime according to the actual laws. You as a customer are responsible by law for the return of all used batteries, a disposal over the household garbage is forbidden!
Batteries containing hazardous substances are marked with the alongside symbols, which point to the prohibition of disposal in household garbage.
Additional notations for the critical heavy metal are Cd=Cadmium, Hg=Quicksilver, Pb=lead {Label is placed on the batteries, for example below the bottom left trash symbols).

Based on RoHS labelling the manufacturer confirms, that all limit values were taken care of at the time of manufacturing.

Batteries labelled with the recycling symbol can be put into used battery collecting tank.
(Most supermarkets have)
They are not allowed to be put into local household garbage.

AMEWI Trade GmbH is involved in the dual system for boxing over the company Landbell AG.
All used boxes are collected from partner companies (waste disposal contractor) at private customers (local household), sorted and properly utilized. The involvement in a Dual Systems helps to save C02 Emissions.

THANK YOU
Thank you for purchasing the Amewi Buzzard Pro XL V2. Please read the instruction manual carefully and keep it for future reference.

WARNING
This remote-controlled model is not a toy. It consists of many small parts and is not suitable for children under 16 years.
Six 1.5V AA batteries are required for the remote control.
A 7,4VV Li-Po battery is used for the model (included).
Always keep your fingers away from the drive parts and other moving parts to avoid injury.
The model’s motor gets very hot. To avoid burn injuries, allow the motor to cool for 10-15 minutes after use before touching it.

ON INAPPROPRIATE USE OF THE PRODUCT
Please do not disassemble or modify the model in any way. Do not use this product improperly or illegally and do not operate it in a manner that could endanger others or yourself.

MAXIMUM TRANSMITTING POWER DATA

Maximum peak power

IMPORTANT NOTES
Note: This product is manufactured according to strict performance guidelines and complies with safety standards and requirements. This product is not suitable for children under 16 years of age. The manufacturer is not liable for any injury or accident caused using abnormal parts, excessive wear and tear, improper assembly, or operation. Please operate this product safely and responsibly.

PRECAUTIONS **

**

Please read the following safety information before using the model.
Please do not use the model in rain, snow, or thunderstorms. If liquid enters the electronics, they may be irreparably damaged.
Please do not use the model in an environment that you cannot see.
Signal interference can cause the model to go out of control. Please do not use the model in the following places:

| Near a radio tower, mobile phone masts or other places with active radio waves.
---|---
| Near crowds or in public places.
| Near rivers, ponds or lakes.
| Near electricity pylons or other transmission towers.

Please do not operate the model if you are tired or unwell, have drunk alcohol or taken drugs – this may cause injury to yourself or others.
To avoid burns, never touch drive parts and motors during or immediately after use as they can be very hot.
Incorrect operation of the transmitter can cause injury to you or others. Be sure to familiarize yourself with the operation before using the model.
Check the model and the remote control before use. Check screws to make sure they are tight.
When you have finished using the model, always switch off the model first and then the remote control. Otherwise, the model may get out of control.
If the model gets out of range, it may get out of control. Please always stay close to the model with the transmitter.

MPORTANT NOTES

• Be sure to read thoroughly the manual before you begin.

• Never reverse connection / disassemble the battery.

• As the product contains small parts, keep it away from small children.

• Do not operate the model on public roads or crowded places.

SPECIFICATIONS

THE HELICOPTER

Changes and errors excepted

THE REMOTE CONTROL

REMOTE CONTROL BATTERY INSTALL

OPERATION

START-UP

1. Connect the battery plug to the side of the power socket. The LEDs on the helicopter start to flash.
2. Switch on the remote control and push the throttle lever all the way up and then all the way down. The LEDs on the helicopter now light up continuously. The connection has been established.

CALIBRATION OF GYRO

Place the helicopter on a level surface. Then press both levers of the remote control down to the left. The status light starts to flash. After approx. one second, you can release the levers. The calibration is complete when the status light is permanently on.

UNLOCK/LOCK HELICOPTER

To lock or unlock the helicopter, press both levers down outside or down inside for about one second. When the helicopter is unlocked, push the throttle up, the helicopter will lift off and hover at about one meter.

ONE-CLICK TAKE-OFF/LANDING

Press the button on the top right of the remote control, the helicopter will automatically take off and hover at about one meter. If you press the button again, the helicopter will land again.

EMERGENCY STOP

In emergency situations, the motors can be stopped immediately via the emergency stop function. To do this, press the two upper, outer buttons simultaneously. The motors stop immediately.
Note: Never perform the emergency stop function if it is not necessary. The helicopter will crash and may be damaged in the process.

SWAP MODE 2/MODE 1

Press and hold the trim button next to the left lever and turn on the remote control. After releasing the button, the remote control will change to Mode 1/Mode 2.

FLYING

TROUBLESHOOTING

The receiver status LED flashes for longer than four seconds. No response to transmitter movement.| Transmitter and receiver are not bound.| Follow the instructions in the Start-up section.
No response after the battery is connected.| 1. battery empty
2. batteries in the remote-control empty.
3. batteries are not inserted correctly.| 1. Always use a fully charged battery.
2. Replace the transmitter batteries with new ones.
3. Make sure that the batteries are inserted correctly.
The motor does not respond to the throttle.| The battery is empty or defective.| Charge or replace the battery
Motor continues to turn after landing.| The motor has not received a stop signal.| Pull the throttle all the way down.
The motor is not running, but the servos are working.| The motor cables have come loose, or the motor is damaged.| Check the motor cables. Replace the motor.
The main rotor turns but the helicopter does not take off.| Defective rotor blades. Battery empty.| Replace the rotor blades. Charge the battery.
Strong vibrations when flying| The rotor blades are deformed.
2. the rotor shaft is crooked.
3. the tail rotor is deformed.
4. the screws on the rotor blades have been tightened too much.| 1. Replace the rotor blades.
2. Replace the rotor shaft.
3. Replace the tail rotor.
4. Loosen the screws.

amewi.com

References

• Ferngesteuerte Fahrzeuge, Boote, Flugzeuge, Hubschrauber und Panzer - amewi.com
• Ferngesteuerte Fahrzeuge, Boote, Flugzeuge, Hubschrauber und Panzer - amewi.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>