JIREH CK0045-ODI Single Probe User Manual
- June 3, 2024
- JIREH
Table of Contents
JIREH CK0045-ODI Single Probe
SPECIFICATIONS
Intended Use
The ODI is a clamp-on mini encoder. It is designed to provide encoded linear position of probes in manual scanning operations.
Performance Specifications
| Wedge Width: | 0 – 55 mm (2.16 in) |
|---|---|
| Encoder Resolution: | 16.00 counts/mm (406.4 counts/inch) |
| Environmental Sealing: | Watertight (submersible), Contact JIREH for details |
Operating Environment
The ODI is designed for use in an industrial environment that is between -20° C (-4° F) and 50° C (122° F).
PREPARATION FOR USE
Probe Attachment
Encoder Setup
Alternate Encoder Position
OPERATION
Hold wedge flat against scanning surface and scan straight in desired direction, ensuring that the encoder wheel is in contact with scanning surface and is rotating in direction of scan.
MAINTENANCE
Wipe the scanner clean as required. Do not soak or submerge the scanner in cleaner or solvent of any kind.
TROUBLESHOOTING
| Problem | Possible Cause | Solution |
|---|---|---|
| Encoder not incrementing | Encoder wheel not in contact with scanning surface. |
Rotate pivot joint until wheel is in contact with scanning surface and spring
joint is slightly depressed (see 2.2)
| Encoder wheel not running in desired scanning direction.| Unscrew pivot
knob separating encoder. Place encoder in alternate encoder position (see
2.3).
| Encoder connector not properly connected to scanning device.| Check scanning
devices instructions on properly connecting an encoder.
SPARE PARTS
| BOM ID | Part # | Description |
|---|---|---|
| 1 | CKS012 | Adjustable Clamp Arm |
| 2 | CK0018 | Clamp Arm, 70 mm (2.8 in) (alternate arm lengths available) |
| 3 | CKS020 | ODI Encoder Mount, with Clamp Arm: 70 mm (2.8 in) |
| **4** | CKS011-X-Y | ODI Spring-Loaded Encoder _(see Encoder Con. Type) |
(alternate cable lengths)_ _
5| CKA008-X-Y| Base ODI – Single Probe (see Encoder Connector Type)
(alternate cable lengths)_
Encoder Connector Type
