GOODSCY XM32 Intelligent Sweeping Robot Vacuum Cleaner User Manual
- July 26, 2024
- GOODSCY
Table of Contents
GOODSCY XM32 Intelligent Sweeping Robot Vacuum Cleaner
Matters needing attention
Before using the intelligent sweeper, please follow the following basic safety precautions:
- Read all the contents of this user guide carefully and operate the product according to the instructions in this user guide.
- Keep this guide properly. If you transfer the product to a third party for use, please attach this manual with the machine. technicians designated by the company. Otherwise, it may cause fire, electric shock or personal injury.
- There shall be no movable wire, wire and other objects longer than 150 mm on the ground to prevent the brush from being entangled. In order to extend the service life of the battery, it is required to charge for 8-9 hours before use for the first time or after long-term use. The best effect can be achieved only after the battery has 2-3 cycles of full charge and discharge.
- If you do not use the intelligent sweeper for a long time, please fully charge the battery, and then take out the battery and put it in a cool place. Keep the bottom of the intelligent sweeper dry.
- When using the remote control, do not aim the infrared emitter at people’s eyes.
About the scope of use of the machine
- It cannot be used to clean the following ground:
- Surfaces with standing water (including flammable liquids), such as wet floors.
- The toilet, shower room, and another humid environment.
- Stairs.
- A place with an open fire.
- The following situations are absolutely prohibited and cannot be used for absorption;
- Unburned ashes, burning butts, or matches (which may lead to pyrotechnics).
- Water or other liquids, such as detergents, kerosene, gasoline, paint, alcohol, perfume, carpet cleaning solution,
- Floor cleaning solution, etc. (internal humidity or water may cause a short circuit of the machine).
- When using and storing the machine, keep away from heat sources such as oven and fireplace (it will cause deformation and aging of the machine shell)
- Do not wet the machine’s body, otherwise, it may be damaged due to a short circuit of the machine.
- Please handle the old battery of this product reasonably, please don’t discard it at will.
Note: when not in use, please turn off the main switch to avoid power consumption of the machine.
Matters needing attention
First of all, thank you for purchasing the “Xi Meijie” intelligent sweeper to
start a better intelligent life!
As this product is an intelligent technology product, please read and be familiar with the following items carefully:
-
This product is equipped with a 2.4G radio remote control, which can be used only after the frequency is matched with the host for the first time
-
Remove the battery cover, install two batteries No.7, and then install them.
-
Turn on the main switch at the bottom of the main engine.
-
Press the middle start button of the remote control for frequency matching.
-
Press the start key in the middle, and the remote control will make a dropping sound, and then it will be in normal use.
-
After the remote control is enabled, there are mode switching and sterilization switching according to your own needs. When the sterilization mode is switched, the ultraviolet light at the bottom will be on (see the instructions on page 7 for details). The remote control belongs to radio wave emission, please do not drop it)
-
The remote control belongs to radio wave signal reception, which may fail them porarily in case of monitoring or strong radio wave interference. You can turn off the power supply at the bottom of the host first, take out the battery at the end of the remote control and put it back into the remote control, and restart the host power supply to carry out frequency matching again, then you can use it normally!
-
Charging precautions:
In use, if the host is out of power, it will send out a drip alarm sound, please charge in time. Generally, the charging time is about 3 hours. The red color is normal when charging. The indicator light will turn off automatically when fully charged. Please unplug the charger in time after fully charged so as not to affect the service life of thebattery. When charging, use the original charging line and connect the charging line with a charger lower than 5V (commonly used mobile phone charger or charger). It is forbidden to use high-power charger or fast charging, otherwise the service life of the product will be affected! -
This product belongs to intelligent touch switch. Wet hands or water in use will affect touch spirit. Please dry it in time in case of the above situations. If the sweeper is not in use for a long time, please turn off the power supply at the bottom, insert (or take out the battery of the remote control) the remote control isolator, and place it in a dry and normal temperature environment for better use next time.
-
Clean the bottom wheel, air inlet, garbage box, etc. in time after using the main engine. Please turn off the power supply at the bottom before cleaning the garbage box.
After cleaning the garbage, do not install the filter cotton cover upside down, and fasten the garbage box buckle to avoid affecting the suction! (see the instructions for details). When cleaning the trash box or filter cotton cover, wait until it is dry before loading it into the host machine. This product is equipped with a pair of brushes and 2 batteries No. 7 for replacement in long-term use!
Thank you for reading carefully. If you have any problems during the use, please contact the agent or manufacturer for after-sales service. Have a good use
Packing list
Thank you very much for using the intelligent sweeper, which is a high-tech
intelligent full-automatic vacuum cleaner, even if you are not at home,it can
also clean the room and create a healthy and comfortable home environment for
you.
Users should not dismantle the machine for maintenance by themselves, but should send it to the maintenance center for maintenance by professionals, or it will be dangerous.
Note: the design of the product is subject to change without notice.
Function introduction
Intelligent function:
Press the switch to clean the room automatically The cleaning process does not
need human monitoring.
Navigation function:
Plan the cleaning route and clean every part of the room.
Safety and energy saving:
Voltage – 7.4v, power 15W cost less than 3 yuan
Environmental protection function:
H20 built in filter screen to effectively filter the ashing air. Duster.
Whirlwind brush:
Six whirlwind brush, high cleaning efficiency.
Slim body:
Ultra thin body, can easily drill to the bottom of the bed or sofa for
cleaning.
Soft rubber wheel design:
The wheels are made of soft rubber, which will not scratch the floor or carpet
Low noise design:
Low noise, far lower than ordinary vacuum absorber
Product parameters
Structure introduction 
Scope of application:
Tile floor, wood floor, marble floor, short wool carpet (carpet wool is
shorter than 15 cm). 
Operation instructions
Diagram of cleaning route:
Intelligent sweeper adopts intelligent control and has powerful functions.
In order to adapt to the complex working environment and high Efficient
cleaning, intelligent sweeper operation mode has the following two.
Host usage:
- Turn the power switch of the main unit to “1”, turn on the power switch, the main unit will sound once, indicating light The blue is always on. If there is no operation within 1 minute, it will automatically enter the sleep mode.
- Te pro* stomaticaly ea according to the planted pathottie system. Anois. time, the indicator light will flash in blue.
How to use the remote control and its functions
Charging method:
Connect the host and power supply with USB charging cable
Cleaning and maintenance
Handling of dust boxes and fan components:
- Open the top cover of the main engine by hand
- Take out the dust box
- Open the dust box cover and take out the filter screen
Cleaning of dust box and fan assembly:
- First remove the dust, and then clean it with a clean brush
- The filter screen can be blown clean with a hair dryer or brushed clean with a cleaning brush. After cleaning, it can be installed firmly according to the reverse order before disassembly and assembly.
Loading and unloading of side brush:
- Before replacing the brush, remove the screws on the main shaft of the brush.
- Then press the side brush into the side brush spindle, and then lock the screw.
Brush cleaning:
- Regularly remove the hair or large dust particles on the brush, and remove the dust at the suction port, and then directly use the cleaning brush to clean the paper scraps or small particles. For the involved hair or yarn and other objects, carefully rotate the brush, cut with scissors or pull out by hand to improve the cleaning performance.
- Cleaning can be carried out by referring to the handling and cleaning of the brush.
Common faults and Solutions
-
The intelligent sweeper cannot work or the cleaning work is weak.
-
Solution:
-
Check whether the switch of intelligent sweeper is on.
-
Check whether the dust box, filter, suction port, etc. have been cleaned
-
Whether the battery voltage drops seriously.
-
Remote control does not work
-
Solution:
-
check the battery status of the remote control.
-
Checkere be tes status of the etective receiving and sending distance of the signal.
-
The intelligent sweeper cannot be charged
-
Solution:
-
Check whether the charging line is normally connected to the host and whether the blue indicator light of the host flashes.
-
Noise increases during cleaning,
-
Solution :
-
Clean the dust box and filter screen.
-
Check whether the brush is too dirty.
-
The intelligent sweeper stops working suddenly during operation and sends out an intermittent sound
-
Solution:
-
Check whether the set time has been cleaned.
-
Check whether the main wheel and side brush of the main engine are stuck.
-
The machine is in trouble
-
Solution:
-
when the machine is cleaning the room, it may get into trouble. In this case, it will try to get rid of the trouble in various ways. Once it can’t get rid of the trouble, please help the machine get rid of the trouble manually and tidy up the obstacles.
The dilemma may be as follows: -
The machine is wound by scattered wires on the ground.
-
The machine is wrapped around the hip of a drapery or carpet
-
There are too many obstacles in front of the machine.
-
Machine cleaning and dust absorption capacity reduced
-
Solution:
-
turn off the power switch of the machine, take out the dust box, and proceed as follows:
-
Check whether there is too much dust accumulated on the filter cotton in the dust box, and observe whether it needs to be replaced.
-
Check whether there is dirt or entanglement at the driving wheel to make it unable to work.
-
If the fault still exists after cleaning according to the above steps, please contact our after-sales service department.
-
Check and clean the edge brush:
-
When the machine is working, it makes a lot of noise
-
Solution:
-
turn off the power switch of the machine, take out the dust box and clean up the production waste, and then turn the bottom of the machine upward.
-
Observe whether the suction port is blocked by garbage;
If the fault still exists after Jiaguo cleans up according to the above steps, please contact our after-sales service department.
FCC WARNING
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Thank you for purchasing this product. Please read the manual carefully before use