CASA FIXTURES CBA-14 Halo 2-Piece Bathroom Hardware Set Installation Guide

Table of Contents

CASA-FIXTURES-CBA-14-Halo-2-Piece-Bathroom-Hardware-Set-
PRODCUT

Series: Halo CBA-14
Warranty: 1 year from the date of purchase
Dimensions:
- CBA-1401: 6-3/4 x 10-5/8 x 3 inches
- CBA-1402 : 7-1/8 x 25-3/4 x 4-1/4 inches
- CBA-1403: 7-1/8 x 23-5/8 x 5-5/8 inches
- CBA-1404 : 6-5/16 x 19-7/8 x 2-7/8 inches
- CBA-1405: 6-5/16 x 17-3/4 x 2-7/8 inches
- CBA-1406: 6-5/16 x 19-7/8 x 2-7/8 inches
- CBA-1407 : 6-5/16 x 17-3/4 x 2-7/8 inches

Single-Post Installation

Loosen the set screw and remove the mounting plate from the accessory.
Position the mounting base and verify the plumb.
Mark the positions of the screw holes.
- For drywall into Studs: Drill 5/16 holes. Use the provided pin to install the drywall anchors. Secure the mounting plate.
- For drywall Between Studs: Drill 1/4 holes. Insert ceramic anchors. Secure the mounting plate.
- For Ceramic Tile: Drill 1/8 holes. Secure the mounting plate.
Slide the accessory onto the mounting plate. Tighten the setscrew.

Two-Post Installation

Loosen the set screw and remove the mounting plate from the accessory.
Position the mounting plate and verify the plumb.
Mark the positions of the screw holes.
- For drywall into Studs: Drill 5/16 holes. Use the provided pin to install the drywall anchors. Secure the mounting plate.
- For drywall Between Studs: Drill 1/4 holes. Insert ceramic anchors. Secure the mounting plate.
- For Ceramic Tile: Drill 1/8 holes. Secure the mounting plate.
Slide the accessory onto the mounting plate. Tighten the setscrew.

These products should be located and mounted to a wall stud. While it is possible to mount them to any surface, a stud-mounted product will yield the best results.
Keep this booklet and the receipt (or other proof of date and place of purchase) for this product in a safe place. The receipt is required to request warranty parts.
Please keep the box and packaging materials until your product is completely installed.

WARNING
This item is not designed for use as a grab bar. Do not mount in locations where the product is likely to be used as a grab bar.

WARNING
Use caution when drilling into walls to avoid drilling into electrical and plumbing lines hidden within the wall.

Cleaning Instructions

To maintain and protect the fine luster of all bath accessories, clean them with a soft, damp cloth only. DO NOT USE scrub pads, detergents or cleansers as they may harm the protective finish of your bath accessories.
Damage to the product caused by improper care or the use of improper cleaning agents is not covered by the warranty.

Warranted to be free from manufacturing defects for one (1) year from the date of purchase.

CASA-FIXTURES-CBA-14-Halo-2-Piece-Bathroom-Hardware-Set-
FIG-1

Loosen the set screw and remove the mounting plate from the accessory.
Position the mounting base and verify the plumb. Mark the positions of the screw holes.
Drill 1/8” holes. Secure the mounting plate.
Drill 5/16” holes. Use the provided pin to install the drywall anchors. Secure the mounting plate.
Drill 1/4” holes. Insert ceramic anchors. Secure the mounting plate.
Slide the accessory onto the mounting plate. Tighten the setscrew.

Loosen the set screw and remove the mounting plate from the accessory.
Position the mounting plate and verify the plumb. Mark the positions of the screw holes.
Drill 1/8” holes. Secure the mounting plate.
Drill 5/16” holes. Use the provided pin to install the drywall anchors. Secure the mounting plate.
Drill 1/4” holes. Insert ceramic anchors. Secure the mounting plate.
Slide the accessory onto the mounting plate. Tighten the setscrew.

Q: What should I do if I accidentally drill into electrical or plumbing lines?
- A: If you accidentally drill into electrical or plumbing lines, stop immediately and consult with a professional to assess and repair the damage.
Q: Can I use scrub pads or cleansers to clean the product?
- A: No, it is recommended to clean with a soft, damp cloth only. Using scrub pads or cleansers may harm the protective finish of the product.