burotic PEAK Ergonomic Chair Installation Guide

: July 23, 2024
: burotic

Table of Contents

burotic PEAK Ergonomic Chair
Assembly guide
Parts and materials
Product Usage Instructions
Function Guide
(FAQ)
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

burotic PEAK Ergonomic Chair

Specifications

Backrest – 1x
Headrest – 1x
Seat – 1x
Casters – 5x
Gas Lift – 1x
Base – 1x
Armrest – 1x
Control Mechanism – 1x
Bolt M8X25 – 4x
Bolt M6X22 – 3x
Bolt M6X35 – 7x
Bolt M8X50 – 3x
Screwdriver – 1x
Washer 6X14X1.5MM – 7x
Washer 8X17X1.5MM – 8x
Spring Lock Washer M8 – 8x
Bolt M8X60 – 3x

Assembly guide

Peak Ergonomic Chair

Caution
Follow each of the steps in this guide to ensure that the chair is properly assembled and supported. Please read the instructions before starting the assembly. Using the illustrations below, verify that all components required for assembly have been supplied with the order. Do not discard the packaging until the product has performed satisfactorily.

IMPORTANT SAFETY INSTRUCTIONS:
Please follow these instructions carefully to avoid any potential injuries:

This product is intended for seating only. Do not stand or use it as a stepladder.
Ensure all bolts and parts are securely tightened before using this product.
If any parts are missing, damaged, or worn, stop using this product and contact the manufacturer for replacement parts.
Do not sit on the armrest of this product.
This product is designed for one person to sit on at a time.
Children under the age of 10 should only use this product under adult supervision.

Parts and materials

Product Usage Instructions

Step 1: Casters Installation
Flip the base upside down and insert the casters into their assigned slots.

Step 2: Gas Lift Installation
Insert the gas lift into the base.

Step 3: Bolt and Washer Fastening
Using the screwdriver, ensure the bolts and washers are tightly fastened into the corresponding holes on the base.

Step 4:
To reveal the screw holes, simultaneously lift the handle and push the mechanism to the end in the direction of the arrow.

Step 5:
Using the screwdriver, insert the bolts, spring lock washers, and washers into the holes on the base and tighten them until they are aligned.

Step 6:
Using the screwdriver, insert the bolts, spring lock washers, and washers into the holes on the base and tighten them until they are aligned.

Step 7:
Place three bolts and their corresponding washers at the location indicated below, securing the chair back to the seat.

Step 8:
Lower the seat on the gas lift.

Step 9:
Place the headrest at the top of the seat back.