burotic DAFS95IfGMA Monitor Arm Installation Guide
- July 16, 2024
- burotic
Table of Contents
burotic DAFS95IfGMA Monitor Arm
Caution
- Please follow each step in this guide to ensure that the monitor arm is properly installed and supported.
- This device contains high-pressure gas springs. To avoid injury, avoid high heat sources.
- Confirm that the work surface can support the weight of the arm as well as the monitor before installation.
- Please read the instructions before starting the installation.
- Verify, using the illustrations below, that all components required for installation have been included in your order.
- Do not discard the packaging until the product has performed satisfactorily.
Parts and materials
Step 1
- Secure the arm to the work surface Loosen the handle.
- Place the arm on the surface and tighten the handle.
Step 2
- Assemble the arm
- Connect the front and rear arm sections.
- Connect each arm to the base.
- Tighten the screws as shown in the figure below.
Step 3
- Connect the arm to the monitor
- Install a VESA plate on the back of the monitor using (4) M4 or M5 screws.
- Then connect the arm to the monitor by inserting the tip of the VESA plate inside the arm.
- To detach the monitor: open the lever of the VESA plate.
Step 4
- Cable management
- Route the cables along the back of the arm for a tidy appearance and clean cable management.
Arm adjustments
Need help?
For assembly assistance, you can contact us by:
Live Chat: burotic.com/chat
Phone: 1-844-287-6842
Email: support@burotic.com
99 Emilien-Marcoux, Suite 107
Blainville, QC J7C 0B4
Canada
1-844-BUROTIC
support@burotic.com
burotic.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>