burotic DAFSCM5VQrA Dual Monitor Arm Installation Guide

: July 16, 2024
: burotic

Table of Contents

burotic DAFSCM5VQrA Dual Monitor Arm
Product Information
Product Usage Instructions
Parts and materials
INSTALLATION STEPS
Arm adjustments
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

burotic DAFSCM5VQrA Dual Monitor Arm

Product Information

Specifications:

Product: Dual-Monitor Arm
Materials: High-quality metal
Compatibility: Supports two monitors
Weight Capacity: Check work surface capability
Adjustability: Tilt angle, horizontal angle, arm height
Cable Management: Yes

Product Usage Instructions

Step 1 – Secure the arm to the work surface:
Loosen the handles, place the arm on the surface, and tighten the handles securely.

Step 2 – Assemble the arms:
Connect the front and rear arm sections, then attach each arm to the base. Tighten the screws securely using the provided tools.

(A) Insert the rear arm into the base rod, and tighten the screw
(A) with the 3mm Allen key.

Step 3 – Connect arms to monitors:
Attach a VESA plate to the back of each monitor using M4 or M5 screws. Connect the arms to the monitors by inserting the VESA plates into the arms. Use the levers on the VESA plates to detach the monitors.

Step 4 – Cable management:
Route the cables along the back of the arm for a neat and organized appearance.

Arm Adjustments:

Adjust tilt angle as needed.
Modify horizontal angle for optimal viewing.
Adjust weight distribution for stability.
Lower arm height by pressing with your hand, raise it by lifting the designated part.

Frequently Asked Questions (FAQ):

Q: What should I do if I encounter issues during installation?
A: If you face any problems during installation, please contact our customer support for assistance. You can reach us through live chat on burotic.com/chat, phone at 1-844-287-6842, or email at support@burotic.com.

Caution

Please follow each step in this guide to ensure that the dual-monitor arm is properly installed and supported.
This device contains high-pressure gas springs. To avoid injury, avoid high heat sources.
Confirm that the work surface is able to support the weight of the arm as well as the monitors before installation.

Please read the instructions before starting the installation. Verify, using the illustrations below, that all components required for installation have been included in your order. Do not discard the packaging until the product has performed satisfactorily.

Parts and materials

INSTALLATION STEPS

Step 1 Secure the arm to the work surface
Loosen the handles.
Place the arm on the surface and tighten the handles.
Step 2 Assemble the arms
Connect the front and rear arm sections together. Connect each arm to the base.
Tighten the screws as shown in the figure below.
Step 3 Connect arms to monitors
Install a VESA plate on the back of each monitor using (4) M4 or M5 screws per monitor.
Then connect the arms to the monitors by inserting the tip of the VESA plates inside the arms.
To detach the monitors: open the levers of the VESA plates.
Step 4 Cable management
Route the cables along the back of the arm for a tidy appearance and clean cable management.