VELOSSA TECH 2021-2023 Hyundai Sonata N-Line BIG MOUTH Ram Air Intake Installation Guide
- July 21, 2024
- VELOSSA TECH
Table of Contents
VELOSSA TECH 2021-2023 Hyundai Sonata N-Line BIG MOUTH Ram Air Intake
Product Information
Specifications:
- Product Name: 2021-2023 Hyundai Sonata N-Line BIG MOUTH Ram Air Intake
- Installation Time: 2 hours
- Tools Required: Basic hand tools
Product Usage Instructions
Stock Components Removal:
It is recommended to refer to specific instructions for removing the bumper
based on your vehicle’s trim.
Kit Contents (Full Kit)
Please review this document before attempting installation. You will need
basic hand tools and 2 hours of installation time.
Stock Components Removal
It is best to Google “how to remove bumper” for your particular trim.
Driver Side Hole Location
The top shroud is integrated into the bumper and will come off as a single
piece with the bumper. It is necessary to drill two ¼” holes into this shroud
to install the Big Mouth but it is recommended to start with a pilot hole
before using the ¼” drill bit.
Use the following references to locate the hole center. Start with the driver-side hole:
- straight edge on the shroud
- the edges that divide the inlet
- the tape measure
- bolt holes on the Big Mouth. This reference is particularly helpful for the driver-side hole.
Mark and drill the driver-side hole. Confirm this hole location is correct before locating the passenger side hole. An enlarged version of this image is available on the next slideand additional images are provided for locating the passenger side hole.
Passenger Side Hole Location
Use the same references from slide 4 along with these images to locate the
hole centerfor the passenger side hole. Mark and drill the passenger side
hole.
Big Mouth Installation
Once the holes are drilled, install the Big Mouth using the provided M5 x 22mm
button head screws and the M5 lock nuts. DO NOT OVERTORQUE.
Final Assembly Review:
Review the installation and make sure nothing is binding or causing any
preload on any parts, loosen and retighten if adjustment is necessary.
FAQ
Q: What should I do if I encounter difficulties during installation?
A: If you face challenges during installation, refer to the manual, seek
professional assistance, or contact customer support for guidance.