KLUS B17002 Profile ROGER Installation Guide
- July 20, 2024
- KLUS
Table of Contents
KLUS B17002 Profile ROGER
Product Specifications
- Profile: ROGER (Ref. A06885)
- End Cap: ROGER (Ref. C20015)
- Cover: BENCO-5 (Ref. B17002)
- LED Tape: * (24 V power supply required)
Product Usage Instructions
To use the ROGER profile with the provided accessories, follow these steps:
Installing the Profile ROGER
Mount the ROGER profile securely in the desired location following the mounting procedures available at www.KlusDesign.eu.
Attaching the End Cap ROGER
Securely attach the end cap ROGER to the profile to ensure a finished look and protection.
Installing the Cover BENCO-5
Place the cover BENCO-5 over the profile to provide a sleek and clean finish.
Connecting the LED Tape
Connect the LED tape to a 24 V power supply to ensure proper functionality.
Note: For more detailed mounting procedures and additional accessories, refer to www.KlusDesign.eu.
FAQ
- Q: Are there any specific requirements for connecting the LED tape?
- A: Yes, all LED tapes must be connected to a 24 V power supply for proper operation.
- Q: Where can I find more mounting procedures and accessories?
- A: Visit www.KlusDesign.eu for a wide range of mounting procedures and related accessories to enhance your installation.
- Q: Are the drawings in the instructions accurate representations of the product?
- A: The drawings in the instructions are simplified and approximate representations of the actual product shapes. For precise details, refer to www.KlusDesign.eu.
INSTALLATION
- Profile ROGER (Ref. A06885)
- End cap ROGER (Ref. C20015)
- Cover BENCO-5 (Ref. B17002)
- LED tape*
The full range of accessories and electronics is available at
www.KlusDesign.eu
NOTE! ! All LED tapes must be connected to a 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at
www.KlusDesign.eu.
Drawings in these instructions are simplified and only approximate the actual
shapes. 
