CHAMPION POWER EQUIPMENT 201412 9200w Tri-Fuel Electric Start Generator Instruction Manual

CHAMPION POWER EQUIPMENT 201412 9200w Tri-Fuel Electric Start Generator

Specifications

• Model: 201412
• Power: 9200W
• Fuel Type: Tri-Fuel (Gasoline, Propane, Natural Gas)
• Electric Start

Product Usage Instructions

Set-Up

1. Attach wheel kit:
   • Attach the wheelset.
2. Connect the battery:
   • Cut cable tie on each side of the battery connector.
   • Push two halves of the battery connector together tightly.
3. Add oil:
   • Recommended: 10W-30, up to 37.2 fl. oz. (1100 ml) DO NOT overfill.
4. Move the generator outdoors.
5. Add fuel (Gasoline, Propane, or Natural Gas).

Start-Up

1. NEVER START OR STOP THE GENERATOR WITH ELECTRICAL DEVICES CONNECTED OR TURNED ON!
2. Select Fuel:
   • Gasoline: Turn the fuel select dial to the GASOLINE ON position.
   • Propane: Turn the fuel select dial to the PROPANE ON position.
   • Natural Gas: Turn the fuel select dial to the NATURAL GAS ON position.
3. Starting the Engine:
   • Gasoline:
   • Electric Start:
   1. Press and hold the ignition switch to the START position.
   2. Move the choke lever to the RUN position.
   • Start Manual:
     1. Pull the starter cord.
     2. Move the choke lever to the RUN position.
   • Propane (LPG) and Natural Gas:
   • Electric Start:
     1. Open the propane tank or natural gas valve.
     2. Press the ignition switch to the START position for 2-3 seconds.
     3. Move the choke lever to the RUN position.
     4. Press and hold the ignition switch to the START position.
     5. If the engine does not start, wait 10 seconds, then repeat step 4.
   • Start Manual:
     1. Open the propane tank or natural gas valve.
     2. Pull the starter cord 2-3 times until you feel some combustion pulses.
     3. Move the choke lever to the RUN position.
     4. Pull the starter cord.

FAQ

• Q: Can I use the generator indoors?
• A: No, using the generator indoors can be fatal due to carbon monoxide poisoning. Always operate the generator outdoors and away from windows, doors, and vents.
• Q: What type of fuel should I use?
• A: The generator is designed to run on Gasoline, Propane (LPG), or Natural Gas (NG). Do not use E15 or E85 gasoline for operation.

PARTS INCLUDED

DANGER

MOVE GENERATOR OUTDOORS

• Using a generator indoors CAN KILL YOU IN MINUTES. Generator exhaust contains carbon monoxide. This is a poison you cannot see or smell.
• NEVER use inside a home or garage, EVEN IF doors and windows are open.
• ONLY use OUTSIDE and far away from windows, doors, and vents.

WARNING

• Read the ENTIRE operator’s manual to become familiar with the features of this product before operation. This QuickStart Guide IS NOT a substitute for the Operator’s Manual.
• Failure to operate the product correctly could result in damage to the product, or personal property or cause serious injury or death.

NOTICE

• Keep all objects at least 5 feet (1.5 m) from the generator. Heat from the muffler and exhaust gas can ignite combustible materials.

SET UP

• Attach wheel kit. Assembly > Install Wheel Kit

Connect the battery. Assembly > Connect the Battery

• Cut cable tie on each side of the battery connector.
• Push two halves of the battery connector together tightly.

Add oil. Assembly > Add Engine Oil

• Recommended: 10W-30, up to 37.2 fl. oz. (1100 ml) DO NOT overfill.

Move the generator outdoors

• ONLY USE OUTSIDE AND FAR AWAY FROM WINDOWS, DOORS, AND VENTS.

• Add fuel – Gasoline, Propane (LPG), or Natural Gas (NG)  Assembly > Add Fuel

• DO NOT plug in any electrical devices.
• NEVER START OR STOP THE GENERATOR WITH ELECTRICAL DEVICES CONNECTED OR TURNED ON!

Select Fuel

Select Fuel. Operation > Starting the Engine

• Gasoline: Turn the fuel select dial to the “GASOLINE ON” position.
• Propane: Turn the fuel select dial to the “PROPANE ON” position.
• Natural Gas: Turn the fuel select dial to the “NATURAL GAS ON” position.

• Move the choke lever to the “CHOKE” position.

STARTUP

Starting the Engine: Gasoline

Electric Start

1. Press and hold the ignition switch to the “START” position.
2. Move the choke lever to the “RUN” position.

Manual Start

1. Pull the starter cord.
2. Move the choke lever to the “RUN” position.

Starting the Engine: Propane (LPG) and Natural Gas

Electric Start

1. Open the propane tank or natural gas valve.
2. Press the ignition switch to the “START” position for 2-3 seconds.
3. Move the choke lever to the “RUN” position.
4. Press and hold the ignition switch to the “START” position.
5. If the engine does not start, wait 10 seconds, then repeat step 4.

Manual Start

1. Open the propane tank or natural gas valve
2. Pull the starter cord 2-3 times until you feel some combustion pulses.
3. Move the choke lever to the “RUN” position.
4. Pull the starter cord.

• Plug in. Operation > Connecting Electrical Loads.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>