Orbegozo MHH 1200 Ice Cube Maker Instruction Manual

ICE CUBE MAKER – INSTRUCTION MANUAL MHH 1200

MHH 1200 Ice Cube Maker

Sonifer, S.A.
Avenida de Santiago, 86, 30007, Murcia, España
sonifer@sonifer.es / www.orbegozo.com
Made in P.R.C.

Read this manual carefully before running this appliance and save it for reference in order to obtain the best results and ensure safe use.

IMPORTANT SAFETY INTRUCTIONS

Dear Customer, if you follow the recommendations contained in this Instruction Manual, our appliance will give you constant high performance and will remain efficient for many years to come. Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. If you give this device to other people, please also pass on the operating instructions.

General Safety Instructions

1. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children must never play with the appliance. Cleaning and user maintenance must never be carried out by children without supervision.
2. Children should be supervised to ensure that they do not play with the appliance.
3. Keep the appliance and the cable cord out of the reach of children less than 8 years old.
4. WARNING: In order to ensure your children‘s safety, please keep all packaging (plastic bags, boxes, polystyrene etc.) out of their reach.
5. If the supply cord is damaged it must be repaired by the Authorized Service Agent.
6. Never pull on the cord when unplugging.
7. Do not use the unit with a damaged cord or plug, or if it is not working properly.
8. Do not handle the appliance with wet hands.
9. Never immerse the appliance in water or any other liquid.
10. Make sure the appliance has been unplugged before cleaning.
11. This appliance must be installed following the national regulations for electrical installations.
12. This appliance is for household use only.
13. In case that you need a copy of the instruction manual, you can find it in www.orbegozo.com
14. WARNING: In case of misuse, there is a risk of possible injury.

SPECIFIC:

When using an electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electric shock and/or injury, including the following:
Read instructions before using.

1. Remove all packaging material and carefully check your ice maker to ensure that it is in good condition and that there is no damage to the ice maker or power cord or plug.

2. WARNING: As refrigerant gases are flammable, professional service technicians will be required to dispose of this device once it is no longer in use.

3. This appliance contains the refrigerant isobutane (R600a), a natural gas that does not harm the environment. Although it is flammable, it does not damage the ozone layer nor does it increase the greenhouse effect. Care must be taken during the appliance transportation and installation to avoid damage to any part of the cooling system. Coolant leakage can cause eye damage.

4. Warning – Refrigeration units running on isobutane (R600a) cannot be placed in areas where there are ignition sources (e.g. unsealed electric contacts or where refrigerant may accumulate in the event of a leak). The type of refrigerant is indicated on the device nameplate.

5. Coolant
   Warning: Fire risk
   If the cooling circuit is damaged:
   – Avoid open flames and any sources of flame.
   – Thoroughly ventilate the room in which the device is situated. It is dangerous to change the composition of this device in any way.

6. Any damage to the cord can cause a short circuit and/or electrocution.
   WARNING:
   

7. When using, repairing, and disposing of the unit, pay attention to the symbol , which indicates a possible fire hazard. There are flammable substances in the refrigerant lines. Keep the appliance away from sources of fire during use, maintenance and disposal.

8. Pure water is not allowed to be used in this unit; spring water is recommended.

9. Before using the ice maker for the first time, wait 2 hours after placing it and keep the transparent lid open for at least 2 hours.

10. Make sure that the voltage meets the voltage range indicated on the rating label and make sure that the ground connection of the plug is in good condition.

11. Do not turn this product over or tilt it at an angle of 45℃.

12. To protect against risk of electric shock, do not pour water on cord, plug, or vent, or immerse appliance in water or any other liquid.

13. Unplug the appliance after use or before cleaning.

14. Keep the appliance 8 cm from other objects to ensure good heat release.

15. Do not use accessories that are not recommended by the manufacturer.

16. Do not use the appliance near flames, hot plates or stoves.

17. Do not turn on the power button frequently (make sure the interval is at least 5 minutes) to avoid damage to the compressor.

18. Do not use it outdoors.

19. Never clean with abrasive powders or hard implements.

20. Keep the instruction manual.

21. To avoid food contamination, respect the following instructions:
    – Periodically clean surfaces that may come into contact with food and accessible drainage systems.
    – Clean the water tanks if they have not been used for 48 hours.
    – If the refrigerator is left empty for long periods, turn it off, defrost it, clean it, dry it and leave the door open to prevent mold from forming inside the appliance).

22. For information regarding the use of the device, please refer to the following paragraphs.

23. WARNING: fill only with potable water.

SPECIFICATIONS

DESCRIPTION OF THE PARTS

1 Transparent lid
2 Micro switch
3 Ice collecting tray
4 Water tank
5 Control panel
6 Front housing| 7 Top lid
8 Evaporator
9 Ice shovel board
10 Handle
11 Rear housing
12 Air vent
13 Ice scoop
---|---

CONTROL PANEL

ICE FULL Ice tray full
ADD WATER Adding water needed
LARGE Large ice cube size
SMALL Small ice cube size
Start / Pause

USE INSTRUCTIONS

Before first use
Make sure to leave a space of 15 cm around the device free of obstacles in order to have good ventilation.
Before using the device for the first time, leave the top lid open for at least two hours.

Step 1
Open the top lid, take out the ice tray and fill the water tank. Don’t fill it over the “MAX” mark in the deposit. In case of doing it, you’ll have to open the drainage plug in the base, release the excess water and close it.

Step 2
Connect the plug to the mains. The device will be in standby, with the large ice cube indicator flashing.
– Press the Start/Pause button and the both large and small ice cube indicator will flash alternatively.
– Press again the Start/Pause button when the ice cube indicator that you wish to make is on. Then, the machine will start working.
The indicator will remain on and the ice cube making will start. Once the cycle finishes, the ice cubes will fall down to its tray and the device will automatically get into defrosting mode and so on.

ATTENTION:
During the first three cycles, the ice cubes making is irregular and probably small.
When the ice deposit becomes full, empty it immediately. Do not let ice overflow from the ice collecting tray, it may block the sensor and stop production.

Tips
When the room temperature is below 15 degrees, select small cube. When the temperature is greater than 30 degrees, it is advisable to select a large cube.
Do not use chemical, acidic or alkaline liquid agents to make ice.
Use only potable water to refill the tank.

Self-cleaning function
Connect the cable to the power, press the Start/Pause button to turn on the device and press it again for two seconds. The device will enter cleaning mode and the four indicators will flash alternately. Do not turn off the device while this mode lasts. Once finished, the device will automatically enter standby mode.

Add water indicator
When this indicator comes on it means that you must refill the water tank. Once done, press the Start/Pause button to restart the job.

Ice tank full indicator.
When the cubes cover the tank where they are falling to the maximum, this indicator will light up. At that moment you must empty the tank and, once the cubes do not exceed the sensor, the device will restart its work automatically.

CLEANING GUIDE

1. Clean the interior, ice tray, water tank and ice scoop frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted water and vinegar solution to clean the inside and outside surface of the ice maker. Rinse well before use.
2. Keep ventilation openings free of obstructions. Do not use mechanical devices or other means to accelerate the defrosting process other than those recommended by the manufacturer.
3. To ensure clean ice, change the water in the reservoir at least once a day. If you don’t use it for a long time, please drain the water and clean it.
4. If the compressor does not work due to lack of water, full ice tank, power failure, etc., it will delay start for 3 minutes after restarting.
5. Always use clean water before beginning ice production, whether at initial installation or after a long period of inactivity.
6. Depending on the actual use of the machine, the filter grid of the water tank should be cleaned periodically to prevent the water inlet from being blocked by scale. Like shown in the next figure.
   – Remove the ice tray and filter cover from the water tank, clean the filter cover with clean water with a brush, and then put them back in place.

TROUBLESHOOTING

1. Please note that if a power failure occurs due to disconnection of the power cord, or if the power button is pressed during an ice making cycle, small pieces of ice may form and become lodged in the ice making cycle. automatic shovel and cause it to get stuck. If this occurs, the ice chunks can be removed by unplugging the power cord and gently pushing the shovel toward the rear and removing the ice chunks, then restarting.
2. Check whether the water tank is flat when the ice shovel cannot remove ice to the ice collecting tray. Otherwise, push the ice shovel gently with your finger and then press Start/Pause to restart.

proper.
Low water indicator on| 1. There is no water
2. The pump is full of air.| 1. Add water until it reaches the MAX mark.
2. Press the Start/Pause button to restart the machine.
The indicator lights on the panel do not light up| 1. Blown fuse
2. No power| 1.Replace the fuse
2.Turn on the power
The ice is too big and with pieces stuck together.| Ice from previous cycles in the water tank.| Remove the ice
Was the ice making process correct, but no ice came out?| 1. The compressor has no refrigerant.
2. Damaged compressor
3. Damaged motor fan| Call technical service
All indicator lights flash at the same time.| 1. The water box is blocked byice.
2. The motor is stuck or damaged.
3. Damaged micro switch| 1. Take out the ice from under the shovel, plug the power back in and press the POWER button. After 3 minutes, the machine will restart automatically.
2 and 3. Call technical service
When the ice tray is full and the machine does not display the ice full icon| 1. Damaged ice full sensor
2. Sunlight interference| 1. Call technical support
2. Make ice indoors, out of direct sunlight

1. If the power cord is damaged, it must be replaced by a service technician or a qualified person to avoid a hazard.
2. Fill only with potable water.
3. It is normal for the surface of the compressor and condenser to reach temperatures between 70 and 90°C during operation, the surrounding areas may be very hot.
4. Due to rapid freezing, ice cubes may become opaque. This is air trapped in the water and will not affect the quality or taste of the ice.

DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance.

DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2014/35/EU and the requirements of the EMC directive 2014/30/EU.

GUARANTEE

This appliance is covered and is entitled to the legal guarantee in accordance with the legislation in force from the date of purchase. Keep the purchase receipt to be able to claim your right to the guarantee. To find the closest service to your location, contact through the following web link: https://orbegozo.com/asistencia-tecnica/

For any type of query, doubt or incident, you can contact us through our email shown on the main page of this manual or through our technical assistance service at https://orbegozo.com/contacto/

Orbegozo is not responsible for components and accessories that are subject to wear and tear due to use, as well as perishable compounds or those that have deteriorated due to improper use. Nor will it be held responsible if the owner has technically modified the device. Check the legal conditions on our website.

References

• Orbegozo Electrodomésticos | Todo para tu hogar y cocina
• Asistencia técnica - Orbegozo Electrodomésticos
• Orbegozo Electrodomésticos | Todo para tu hogar y cocina
• Contacto - Orbegozo Electrodomésticos

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>