Shark AZ4000 Power Detect Pro Max Upright Vacuum User Guide
- July 17, 2024
- Shark
Table of Contents
Shark AZ4000 Power Detect Pro Max Upright Vacuum
Product Information
Specifications
- Smart Detect Technology Suite
- FloorDetectTM: Identifies surface type and adjusts brushroll speed and suction for optimized cleaning.
- DirtDetect: Identifies dirty areas and automatically boosts suction power to pull in hidden dirt.
- EdgeDetect: Focuses and maximizes suction along corners and edges to target stubborn dirt.
Product Usage Instructions
Detect Indicators
- DIRTDETECT INDICATOR
- EDGEDETECT INDICATORS
- LEFT EDGE – DIRTDETECT INDICATOR (WHITE)
- BOOST EDGEDETECT INDICATORS (PURPLE)
- RIGHT EDGE – DIRTDETECT INDICATOR
Cleaning the Detect Sensors
Clean the sensors when the DIRTDETECT icon turns red. If the sensors are
partially obstructed, Detect mode will not function as expected. If the icon
is still red after cleaning, refer to Detect Sensor Maintenance in the Owner’s
Guide.
To Clean the Sensors:
- Turn off power and remove the floor nozzle.
- Locate the DirtDetect sensor in the nozzle, the FloorDetect sensor on the bottom of the nozzle, and the EdgeDetect sensors on both sides of the nozzle.
- Gently wipe the sensors with a microfiber cloth and remove all hair and debris.
- Reattach the floor nozzle to the rest of the unit and turn on power. Verify the unit is functioning normally.
FAQ
- Q: What should I do if the Detect indicators are not working properly?
A: If the Detect indicators are not functioning as expected, first check if the sensors are clean and free from any obstructions. Follow the cleaning instructions provided in the manual. If the issue persists, contact customer support for further assistance.
SETTINGS
Touchscreen Selector: To switch between modes, gently tap the desired mode icon.
- Detect Mode: Select Detect mode to activate Smart Detect Technology. In this mode, the vacuum will detect floor type, dirt, and edges, and will automatically adjust suction to maximize cleaning performance.
- Manual Surface Modes: Select one of the manual surface modes (Hard Floor, Carpet, or Thick Carpet) to clean specific surfaces without Smart Detect Technology.
SMART DETECT TECHNOLOGY SUITE
FLOORDETECT™
Identifies surface type and adjusts brushroll speed and suction for optimized
cleaning.
DIRTDETECT
Identifies dirty areas and automatically boosts suction power to pull in
hidden dirt.
EDGEDETECT
Focuses and maximizes suction along corners and edges to target stubborn dirt.
DETECT INDICATORS
SENSOR CLEANING
Clean the sensors when the DIRTDETECT icon turns red. If the sensors are partially obstructed, Detect mode will not function as expected. If the icon is still red after cleaning, refer to Detect Sensor Maintenance in the Owner’s Guide.
CLEANING THE DETECT SENSORS
SENSORS REQUIRE CLEANING (RED)
TO CLEAN THE SENSORS:
- Turn off power and remove the floor nozzle.
- Locate the DirtDetect sensor in the nozzle (Fig. 1), the FloorDetect sensor on the bottom of the nozzle (Fig. 2), and the EdgeDetect sensors on both sides of the nozzle (Fig. 3).
- Gently wipe the sensors with a microfiber cloth and remove all hair and debris.
- Reattach the floor nozzle to the rest of the unit and turn on power. Verify the unit is functioning normally.
©2024 SharkNinja Operating LLC. SHARK is a registered trademark of SharkNinja Operating LLC. FLOORDETECT and POWERDETECT are trademarks of SharkNinja Operating LLC.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>