Vtech 838997 2 In 1 Map And Go Scooter Instruction Manual
- July 17, 2024
- vtech
Table of Contents
Vtech 838997 2 In 1 Map And Go Scooter
Specifications
- Product: 2-in-1 Map & Go ScooterTM
- Recommended Age: 2-5 years
- Battery Requirement: 2 AA (AM-3/LR6) batteries
- Material: Plastic
- Color: Multi-color
Product Usage Instructions
Getting Started
- Make sure the unit is turned Off.
- Find the battery cover located on the back of the Driving Panel, use a screwdriver to loosen the screw and then open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
- Replace the battery cover and tighten the screw to secure.
Assembly Instructions
- Insert the Seat Back Handle into the slots on the back of the Seat. Press down on the Handle until you hear it snap into place.
- Insert the Handlebars into either side of the Driving Panel. Push until you hear the Handlebars snap into place.
- Insert the Front Wheel Cover into the front of the Scooter Body. Press until you hear the Front Wheel Cover Tabs snap into place.
- Attach the Driving Panel Support Post to the bottom of the Driving Panel, securing the pieces together with the four Small Screws.
- Insert the Front Wheel into the bottom of the Scooter Body. Push until you hear the Front Wheel snap into place.
- To assemble the Back Wheels in the Scooter position, push the two Back Wheels together. Shorten the Long Axel by pressing the rounded end toward the squared off end, then place the Wheels between the two Wheel Supports on the Scooter. Slide the Short Axel and the Long Axel through the corresponding sized holes on the Scooter until you hear the two axels snap together. Ensure the wheels are secured properly before using the Scooter.
- To remove the Back Wheels, slide and hold the Wheel Lock while pulling out the Small Axel. Next, slide and hold the Wheel Lock and pull out the Long Axel, then remove and separate the two Wheels.
FAQ
-
Q: Is adult assembly required for this product?
A: Yes, adult assembly is required for this product to ensure safety. -
Q: What type of batteries does this product use?
A: The product requires 2 AA (AM-3/LR6) batteries for operation.
Instruction Manual
2-in-1 Map & Go Scooter™
INTRODUCTION
Thank you for purchasing the 2-in-1 Map & Go Scooter™!
Ride through playtime with the scooter that grows with tiny travelers starting
as a three-wheeled trike, then transforming into a two-wheeled scooter.
Explore locations on the map, twist the headlight ring and add in traffic and
road safety phrases to make the journey as delightful as the destination!
INCLUDED IN THE PACKAGE
WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable
tags, cable ties, cords and packaging screws are not part of this toy, and
should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
CAUTION:
Adult assembly required. This package contains small parts. For your child’s
safety, do not let your child play with the toy until it is fully assembled.
Unlock the Packaging Locks
- Rotate the packaging locks counterclockwise 90 degrees.
- Pull out the packaging locks and discard.
LABEL APPLICATION
Please securely stick the labels to the scooter as indicted below:
GETTING STARTED
Battery Removal and Installation
- Make sure the unit is turned Off.
- Find the battery cover located on the back of the Driving Panel, use a screwdriver to loosen the screw and then open the battery cover.
- Remove old batteries by pulling up on one end of each battery.
- Install 2 new AA (AM-3/LR6) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
- Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation. Keep batteries out of
reach of children.
IMPORTANT: BATTERY INFORMATION
- Insert batteries with the correct polarity (+ and -).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not short-circuit the supply terminals.
- Remove batteries during long periods of non-use.
- Remove exhausted batteries from the toy.
- Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
- Remove rechargeable batteries (if removable) from toy before charging.
- Rechargeable batteries are only to be charged under adult supervision.
- Do not charge non-rechargeable batteries.
ASSEMBLY INSTRUCTIONS
With the 2-in-1 Map & Go Scooter™ safety comes first. To ensure your child’s safety, adult assembly is required. For your child’s safety, do not let your child play with the toy until it is fully assembled.
-
Insert the Seat Back Handle into the slots on the back of the Seat. Press down on the Handle until you hear it snap into place.
-
Insert the Handlebars into either side of the Driving Panel. Push until you hear the Handlebars snap into place.
-
Insert the Front Wheel Cover into the front of the Scooter Body. Press until you hear the Front Wheel Cover Tabs snap into place.
-
Attach the Driving Panel Support Post to the bottom of the Driving Panel, securing the pieces together with the four Small Screws.
-
Insert the Front Wheel into the bottom of the Scooter Body. Push until you hear the Front Wheel snap into place.
-
To assemble the Back Wheels in the Scooter position, push the two Back Wheels together. Shorten the Long Axel by pressing the rounded end toward the squared off end, then place the Wheels between the two Wheel Supports on the Scooter. Slide the Short Axel and the Long Axel through the corresponding sized holes on the Scooter until you hear the two axels snap together. Ensure the wheels are secured properly before using the Scooter.
-
To remove the Back Wheels, slide and hold the Wheel Lock while pulling out the Small Axel. Next, slide and hold the Wheel Lock and pull out the Long Axel, then remove and separate the two Wheels.
-
To assemble the Back Wheels in the Tricycle position, slide the Short Axel through the outside of one of the Wheels, then
through the corresponding hole in one of the Scooter’s Wheel Supports. Next, press the button on the Long Axel and pull to extend the axel. Slide the Long Axel through the other Wheel. Insert the protruding end of this axel through the hole of the other Wheel Support. Push until it slides into the Short Axel and you hear the two snap together.
-
Please check the Wheel Locks before using the scooter. The Wheel Locks will spring into the locked position when the Wheel Axels are properly installed.
PRODUCT FEATURES
-
On/Off/Volume Switch
To turn the unit On, turn the On/Off/ Volume Switch to the Low volume or High volume position. You will hear a sound, a phrase and a song.
To turn the unit Off, turn the On/Off/ Volume Switch to the Off position. -
Automatic Shut-Off
To preserve battery life, the 2-in-1 Map & Go Scooter™ will automatically shut down after approximately 45 seconds without input. The unit can be turned On again by pressing any button, twisting the Ring or turning the Map.
NOTE
If the unit powers down or if the light fades out during play, please install
a new set of batteries.
ACTIVITIES
-
Light-up Buttons
Press the Light-up Buttons to hear playful music, fun phrases about colors, traffic lights, counting and fun sounds. The lights will flash with the sound. -
Rolling Map
Turn the Rolling Map to one of the four positions to identify the locations through fun phrases and sounds associated with the locations. The lights will flash with the sound. -
Twisting Headlight Ring
Turn the Twisting Headlight Ring to hear a variety of fun sounds. The lights will flash with the sound. -
Motion Sensor
Roll the Scooter to activate the Motion Sensor and hear playful driving sounds. The lights will flash with the sound.
MELODIES
- Bicycle Built for Two
- Did You Ever See a Lassie?
- On Top of Old Smokey
- Aiken Drum
- A-Tisket, A-Tasket
- The Wheels on the Bus
- Pussy Cat, Pussy Cat
- Jack Be Nimble
- London Bridge
- Boys and Girls Go Out to Play
- Hey, Diddle Diddle
- Skip to My Lou
- Do You Know the Muffin Man?
- Here We Go Round the Mulberry Bush
- While Strolling Through the Park
- The Alphabet Song
SONG LYRICS
-
Song 1
Are you ready? Are you ready?
Time to ride, time to ride.
Don’t forget your helmet, hold on to the handles. One, two, three, off we go! -
Song 2
When we’re riding on the road,
The traffic lights tell us what to do.
When the light turns red, it’s time to stop. -
Song 3
Rollin’, rollin’ down the road.
We pass the forest and zoom by the beach, Then drive throught the city, on our way home!
CARE & MAINTENANCE
- Keep the unit clean by wiping it with a slightly damp cloth.
- Keep the unit out of direct sunlight and away from any direct heat sources.
- Remove the batteries if the unit will not be in use for an extended period of time.
- Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow these steps:
- Turn the unit Off.
- Interrupt the power supply by removing the batteries.
- Let the unit stand for a few minutes, then replace the batteries.
- Turn the unit On. The unit should now be ready to use again.
- If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE
If the problem persists, please contact our Consumer Services Department at
1-800-521-2010 in the U.S. or
1-877-352-8697 in Canada, or by going
to our website at vtechkids.com and filling out our
Contact Us form located under the Customer Support link. Creating and
developing VTech products is accompanied by a responsibility that we take very
seriously. We make every effort to ensure the accuracy of the information,
which forms the value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions that you might have. A
service representative will be happy to help you.
NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
- Trade Name: VTech®
- Model: 5723
- Product Name: 2-in-1 Map & Go ScooterTM
- Responsible Party: VTech Electronics North America, L.L.C.
- Address: 1156 W. Shure Drive, Suite 200
- Arlington Heights, IL 60004
- Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
- THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
- THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)
Visit our website for more information about our products, downloads,
resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty
TM & © 2024 VTech Holdings Limited. All rights reserved.
IM-572300-000
Version:0
Documents / Resources
|
Vtech 838997 2 In 1 Map And Go
Scooter
[pdf] Instruction Manual
838997 2 In 1 Map And Go Scooter, 838997, 2 In 1 Map And Go Scooter, And Go
Scooter, Go Scooter, Scooter
---|---
References
- Best Kids Tech Toys | Electronic Learning Toys | VTech America
- Best Kids Tech Toys | Electronic Learning Toys | VTech America
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>