STK01B Inventum Stacking Stapel Kit User Manual
- July 16, 2024
- INVENTUM
Table of Contents
STK01B Inventum Stacking Stapel Kit
Specifications
- Product: STK01B Stapelkit
- Manufacturer: Inventum
- Model: STK01B
Product Usage Instructions
Installation Steps:
- Ensure the power supply is disconnected before starting the installation process.
- Clean the top cover of the washer.
- Remove the backing from the stickers.
- Align bracket B with the washing machine and stick bracket B using the stickers on the bottom of the bracket.
- Adjust the dryer’s feet to the lowest position if the base is not made of metal.
- If the dryer base is metal, follow these steps:
- Unscrew the front two adjustment feet of the dryer downwards.
- Insert two fixing parts D.
- Tighten the two adjustment feet upwards.
- Place the dryer on top of the washer against the back and push it forward until the holes align.
- If the dryer base is not metal, tighten all four screws G at the front and back.
- If the dryer base is metal, only tighten the front two screws A.
FAQ
-
What should I do if I encounter issues during installation?
If you face any difficulties during installation, please refer to the user manual for troubleshooting steps or contact our customer support for assistance. -
Can I use this stack kit with all types of washers and dryers?
The STK01B Stapelkit is designed to work with specific models, please check compatibility with your washer and dryer before installation. -
Are additional tools required for installation?
Basic tools may be required for installation. Please refer to the user manual for a list of recommended tools.
ASSEMBLY INSTRUCTION
-
STEP 1:
Make sure that the power supply is disconnected before installation! -
STEP 2:
Torque should not exceed 5 N.m -
STEP 3:
Clean the top cover of washer -
STEP 4:
Please note, remove the backing of the stickers -
STEP 5:
Note: Align the bracket B and the washing machine before sticking the bracket B with the stickers on the bottom of the bracket -
STEP 6:
If the dryer base is not metal, adjust the adjusting feet of the dryer to the lowest position directly -
STEP 7:
If the dryer base is metal:
1. Unscrew the front two adjustment feet of the dryer downwards
2. Insert two fixing parts D
3. Tighten the two adjustment feet upwards-
STEP 8:
Place the dryer at the back of the top of the washer and then push the dryer forward until the hole matches the hole -
STEP 9:
If the dryer base is not metal, tighten the front and rear four screws G. -
STEP 10:
If the dryer base is metal, only tighten the front two screws A. -
**STEP 11:
**
ABOUT COMPANY
- Postbus 5023
- 6802 EA Arnhem
- www.inventum.eu
- facebook.com/inventum1908
- pinterest.com/inventum1908
- youtube.com/inventum1908
- instagram.com/inventum1908