Karibu 93729 Finnish Sauna 5kW Furnace Instruction Manual
- July 14, 2024
- Karibu
Table of Contents
Karibu 93729 Finnish Sauna 5kW Furnace
Specifications
- Model Number: 93729
- Product Dimensions: 1608 x 2156 x 390 mm
- Material: Various sizes as listed in the manual
Product Usage Instructions
Determining and Cutting Length:
Before starting assembly, determine the required length based on your project
needs. Cut the pieces to the appropriate length using a saw
Assembly Process
Follow the steps below for smooth assembly
- Check the list of materials provided in the manual.
- Match the components with the list to ensure nothing is missing.
- Begin assembling according to the provided instructions. Use the accessories included in the package for a secure fit.
Temporary Fixing:
During assembly, some parts may need temporary fixing before final assembly.
Ensure these temporary fixes are secure and do not hinder the overall assembly
process.
Inventory Check:
Prior to starting assembly, compare the listed materials with the contents of
your package to verify everything is included. Note that complaints can only
be processed before assembly.
FAQ:
Q: What should I do if I encounter missing parts during assembly?
A: If you find any missing parts, contact customer support immediately with
your order details to request the necessary components.
Q: Can I customize the dimensions of the product?
A: While the product comes with specific dimensions, minor adjustments may be
possible during assembly to suit your requirements. However, ensure these
modifications do not compromise the structural integrity of the product.
Building Instructions
First compare the list of materials with your package contents! Please understand that complaints can be processed in the non-built status only!
Glue! Look for the same height
Roofi ng felt installation
Note! This description is only an example!
The number of bitumen strips to be used depends on your actual house size.
When joining rolls of roofi ng felt end to end, the overlap must be
approximately 10cm. The roof is not safe to walk on. The roof is designed for
a total load (snow, wind) and not for a point load. We recommend you to always
support the roof from below during installation. The sealing of the roof
surfaces to adjacent components with bitumen sealant has to be effected by the
customer! If it is a saddle-roofed house, do not use roofi ng tiles for roofi
ng. In this case, a 20 cm wide strip of bitumen with overhang should be
installed on both sides of the eaves. For houses with a tonne roof, please
install a bitumen roofi ng under the shingles. In the case of a fl at roof the
laying of roof shingles is not possible!
Width side up
This figure shows the functional principle of the board. Regulate the exhaust
air according to your own wishes 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>