GIGABYTE GC-WBAX200 Motherboard Installation Guide

June 3, 2024
Gigabyte

GIGABYTE GC-WBAX200 Motherboard Installation

Installing the Wi-Fi/Bluetooth Card

  • Step 1: Install the Wi-Fi/Bluetooth card in a PCI Express x1 slot. Connect one end of the USB cable to the USB connector on the Wi-Fi/Bluetooth card.
  • Step 2: Connect the other end of the USB cable to the F_USB connector on the motherboard.
  • Step 3: Tighten the antenna cables to the antenna connectors on the Wi-Fi/Bluetooth card respectively.
  • Step 4 Then move the antennas to a place where the signal is good.

Installing the Drivers and Utilities

After the computer starts, install the driver for the Wi-Fi/Bluetooth Card. Adjust your wireless LAN configuration based on your environment after installing the driver.

Regulatory Notices

CAUTION: The manufacturer is not responsible for any interference caused by unauthorized modifications andlor use of unauthorized antennas. Such changes andlor modifications not expressly approved by the party responsible for compliance of this device could void the users authority to operate the equipment

RF exposure statement / Antenna Use
Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

  • Do not touch or move antenna while the unit is transmitting or receving.
  • Do not hold any component containing the radio such that the antenna is very close or touching any exposed parts of the body, especially the face or eyes, while transmiting.
  • Do not operate the radio or attempt to transmit data unless the antenna is connected; this behavior may cause damage to the radio.

Federal Communications Commission Statement

United States of America
Supplier’s Declaration of Conformity 47 CFR $ 2.1077 Compliance Information

Product Name: PCle add-in card
Trade Name: GIGABYTE
Model Number: GC-WBAX200

Responsible Party – U.S. Contact Information: G.B.T. Inc. Address: 17358 Railroad street, City Of Industry. CA91748 Tel.: 1-626-854-9338B
Intenet contact information: https://www.gigabyte.com

FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules, Subpart B, Unintentional Radiators. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any intererence received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digjital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with manufacturers instructions, may cause harmtul interterence to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause hamful interíerence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to corect the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment to an outlet on a circuit diferent from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

Notice for 5GHz
Operations in the 5.15-5.25GHz band are restricted to indoor usage only. (For 5GHz only)

Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This class B digital apparatus complies with Canadian ICES-003.

Canada-Industry Canada (1C) Regulatory statement
This device complies with Canadian RSS-210. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following twO conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Cauton: hen using EEE 802.1a wireless LAN, this product is resticted to indoor use due to its operaton in the 5.15t0 5.25-GHZ frequency range. Industy Canada requires this product to be used indoors for the frequency range of 5.15 GHz to 5.25 GHz to reduce the potential for harmful interference to co- channel mobile satellite systems. High power radar is allocated as the primary user of the 5.25- to 5.35-GHz and 5.65 to 5.85-GHz bands. Ihese radar stations can cause interference with andor damage to this device. The maximum allowed antenna gain for use with this device is 6dBi in order to comply with the E.l.RP limit for the 5.25-t0 5.35 and 5.725 to 5.85 GHz frequency range in point-t0-point operation. To comply with RF exposure requirements all antennas should be located at a minimum distance of 20cm, or the minimum separation distance allowed by the module approval, from the body of all persons.

Radiation Exposure Statement:
Under Industry Canada regulations, this radio transmiter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. lo reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful Communication.

European Union (EU) CE Declaration of Conformity
This device complies with the following directives: Electromagnetic Compatibility Directive 2014/30/EU, Low-voltage Directive 2014/35/EU, Radio Equipment Directive (RED) 2014/53/EU, RoHS directive (recast) 2011/65/EU & the 2015/863 Statement. This product has been tested and found to comply with all essential requirements of the Directives.

European Union (EU) RoHS (recast) Directive 201/65/EU & the European Commission Delegated Directive (EU) 2015/863 Statement
GIGABYTE products have not intended to add and safe from hazardous substances (Cd, Pb, Hg, Cr-6, PBDE, PBB, DEHP, BBP, DBP and DIBP). The parts and components have been carefully selected to meet RoHS requirement. Moreover, we at GIGABYTE are continuing our efforts to develop products that do not use internationally banned toxic chemicals.

European Union (EU) Community Waste Electrical & Electronic Equipment (WEEE) Directive Statement
GIGABYTE will fulfill the national laws as interpreted from the 2012/19/EU WEEE (Waste Electical and Electronic Equipment) (recast) directive. Ihe WEEE Directive specifies the treatment, collection, recycling and disposal of electric and electronic devices and their components. Under the Directive, used equipment must be marked, collected separately, and disposed of properly.

WEEE Symbol Statement
The symbol shown below is on the product or on its packaging, which indicates that this product must not be disposed of with other waste. Instead, the device should be taken to the waste collection centers for activation of the treatment, collection, recycling and disposal procedure. For more information about where you can drop off your waste equipment for recycling, please contact your local government office, your household waste disposal service or where you purchased the product for details of environmentally safe recycling.

End of Life Directives-Recyclingy The symbol shown below is on the product or on its packaging, which indicates that this product must not be disposed of With other waste. Instead, the device should be taken to the waste collection centers for activation of the treatment, O Collection, recycling and disposal procedure

Contact point for EU based customers
G.B.I. Technology Trading GmbH Am Stadtrand 63, 22047 Hamburg, Germany
tel: +49-40-25 33 040

European Community Directive RED Directive Compliance Statement:
This equipment is suitable for home and office use in all the European Community Member States and EFTA Member States The low band 5.15-5.35 GHz is for indoor use only for the countries listed in the table below

Wireless module country approvals:
Wireless module model name: AX200NGW Wireless module manufacturer Intel Corporation

GIGABYTE-GC-WBAX200-Motherboard-Installation-fig-9

China RoHs Compliance Statement
Environment-friendly use period ****Administrative Measures for the Restricted Use of Hazardous Substances in Electrical and Electronic Products (China RoHS Declaration)
Hazardous Substances TableGIGABYTE-GC-WBAX200-Motherboard-Installation-
fig-10Korea Wireless Statement:5.15-5.35GHz
Japan Wireless Statement:5.15GHz 5.35GHz5:
Taiwan NCC Wireless Statements /BSMI CNS15663

Declaration of the Presence Condition of the Restricted Substances Marking GIGABYTE-GC-WBAX200-Motherboard-Installation-fig-12

Documents / Resources

| GIGABYTE GC-WBAX200 Motherboard [pdf] Installation Guide
GC-WBAX200 Motherboard, GC-WBAX200, Motherboard
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals