KOHLER Rite-Temp K-8304-KSL Valve Body and Cartridge Kit Complete Owner’s Manual

July 11, 2024
Kohler

KOHLER Logo Rite-Temp®
Valve Body & Cartridge Kit Complete
K-8304-KSL
KOHLER Rite Temp K 8304 KSL Valve Body and Cartridge Kit
Complete

Codes/Standards

ASME A112.18.1/CSA B125.1
ASSE 1016/ASME A112.1016/CSA B125.16
IAPMO Certification
KOHLER® Faucet Lifetime Limited Warranty
See website for detailed warranty information.

Features

  • Includes valve body, pressure balance cartridge, rough-in guide, and mudguard
  • 1/2″ Universal NPT and direct sweat inlets and outlets with stops (uninstalled kit)
  • Service stops supplied loose (not factory-installed in valve body); ready for making sweat connections to valve inlets
  • Service stops include integral check valves
  • 5 gpm (18.9 l/min) maximum flow rate at 45 psi
  • Single lever design cycles from off through cold to hot
  • Antiscald protection
  • One-piece cartridge design simplifies installation and

Maintenance

  • Adjustable high-temperature limit stop to control maximum water temperature
  • Requires valve trim to complete installation (sold separately)
  • Pressure-balancing diaphragm technology maintains outlet temperature within +/-3°F during water pressure fluctuations

Material

  • Forged dezincification-resistant brass body provides long term reliability and resistance to aggressive water conditions Installation
  • Designed for use in standard, back-to-back and thin wall installations
  • Valve body features integral mounting locations and symmetrical valve inlets to simplify installation
  • Cartridge is reversible for installations where hot and cold supplies are reversed
  • Rough-in guide designed for both standard and thin wall installations
  • Installed valve rough-in can be flushed and pressure-tested to 150 psi max (air or water) without cartridge by using test cap (sold separately)

Optional Products/Accessories
K-10350 Deep rough-in kit
K-10351 Test cap for K-8300 Series valve bodies

KOHLER Rite Temp K 8304 KSL Valve Body and Cartridge Kit Complete -
Port

Technical Information

All product dimensions are nominal.
Shower Valve:

Pressure: 45 psi (3.1 bar)
Maximum (Static) Pressure: 125 psi (8.6 bar)
Minimum (Operating) Pressure: 20 psi (1.4 bar)

Notes
Install this product according to the installation instructions.
Avoid cross-flow conditions. Do not install shutoff device on either valve outlet. Cap the shower outlet if deck-mount spout, diverter, or hand shower is connected to the spout outlet. Install straight pipe or tube drop of 7″ (178 mm) to 18″ (457 mm) with single elbow between the valve and wall-mount spout. For finished walls greater than 3/4″ (19 mm) and less than 1-1/2″ (38 mm), install support(s) 2″ (51 mm) from the stud face. For finished walls greater than 1-1/2″ (38 mm), install support(s) 3″ (76 mm) from the face of the finished wall.

1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com USA or www.kohler.ca Canada
6-15-2024 20:52 – US

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals