power up 192-540796 Wireless Headset User Guide

July 10, 2024
power up

power up 192-540796 Wireless Headset

Charging the Earbuds

  1. Place both Earbuds into their respective charging ports. If the charging case is charged, the LEDs on the case will light up and start charging the Earbuds.
  2. When the charging is completed, the Earbuds will show Blue LEDs and the case will show Green.
  3. All LEDs will then turn off.

Front View

power-up-192-540796-Wireless-Headset-fig-2 Bottom View

power-up-192-540796-Wireless-Headset-fig-3

Linking Earbuds & Pairing Bluetooth

  1. Remove both Earbuds from the charging case and they will automatically start searching for a connection from a Bluetooth® 11 enabled device. Connect to AirBass on your device’s Bluetooth®  settings and a voice prompt will announce “Connected”.
  2. Press and hold down both Function buttons on each of the Earbuds until they start blinking Blue & Red. They will automatically  pair with each other and, once linked, connect to 11AirBass11 on your device’s Bluetooth® settings and a voice prompt will announce
  3. Audio played through the connected Bluetooth device will now be heard through both earbuds. Use the controls on the connected device to play audio and adjust the volume.

Speakerphone

  1. To accept a call, tap the Function button once on either Earbud or use the controls on the connected device. To end the call, tap the Function button once.
  2. To reject the call, press and hold wither Function button for 3 seconds.

PLEASE NOTE: Due to the nature of truly wireless earbuds, you may experience slight interruptions with your audio in areas with multiple 2.4 GHz bands or in high wireless traffic areas.

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Additional Warnings

  • WARNING: To prevent fire or shock hazards, do not expose this unit to rain or moisture.
  • WARNING: Where the main plug or appliance coupler is used as the disconnect device, such disconnect device shall remain readily operable.
  • Lithium batteries, like all rechargeable batteries, are recyclable and should be recycled or disposed of according to state and local guidelines. They should never be disposed of in normal household waste, and they should never be incinerated, as they might explode. Contact your local government for disposal or recycling practices in your area.
  • This product meets and complies with all Federal regulations.
  • To avoid hearing damage, make sure that the volume on your music player is turned down before connecting your headphones. After placing headphones in/on your ears, gradually turn up the volume until you reach a comfortable listening level. The

WARNING

Cancer and Reproductive Harm – www.P65Warnings.ca.gov

Bluetooth® word marks and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Lynea Products® is under license.
Siri® is a trademark of Apple Inc.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals