LEXIN LX-S3 Motorcycle Waterproof Bluetooth Speaker User Manual
- July 21, 2024
- LEXIN
Table of Contents
LEXIN LX-S3 Motorcycle Waterproof Bluetooth Speaker User Manual
Introduction
The LX-S3 is a waterproof 3” motorcycle speaker with specification v4.0
supporting A2DP stereo, FM Radio & 100W power amplifier built inside the
housing. You can stream the stereo music wirelessly from the Bluetooth mobile
phone, or USB audio source.
( Note: only compatible with USB 3.0 below 32 GB)
Package Contents
- LX-S3 Main Speaker x1 and Slave Speaker x1
- Upper and Lower Bracket x4
- Power Cord x1
- Non-slip Meson x2
- Screw x 4
- Screw Driver x1
- Bushings x6
- Ties x4
- Antenna x1
Installation Instructions
Step 1: Mount each speaker with its clamp to the handlebar of the motorcycle.
Note: For different sizes of handlebars please insert different slots of the bracket as below.
Step 2: Plug the speaker connector of the main speaker to the slave speaker.(Fig.①)
Note: Please remember the two arrows on each connector should be on one
line.
Step 3: Connect the RED power wire to the positive of the motorcycle
battery, and the BLACK wire to the negative. Then plug in the power cable to
the main speaker.(Fig.②)
Step 4: Connect the external antenna to the main speaker antenna
connector.(Fig③)
Step 5: Find a place to locate the antenna with 3M adhesive on the
motorcycle, and extend the external antenna for FM reception when used.
General Operation Instructions
Power On
Short press the knob to power on the Bluetooth speaker.
Power Off
Press & hold the knob for 2 seconds to power off the Bluetooth speaker.
Charge Mobile Phone
Plug in the USB Charging cable to the USB port to charge a mobile phone or any
DC5V electronics devices. The charging power output is 2A.
Note: For waterproof remember to cover the USB port when you don’t use
it.
Pairing a Mobile Phone
- Power on the LX-S3, and there will be a voice prompt “Bluetooth Mode”, and the light on the speaker will blink blue to enter pairing mode; -Search for Bluetooth devices on your mobile phone.
- The speaker will be listed on your mobile phone as “LX-S3” Your mobile phone will confirm that pairing is complete, and then the LED light on the speaker will stay blue.
Controls and Functions
Volume and Music Control
You can easily adjust the volume by rotating the knob clockwise for volume up or counterclockwise down. You will hear a tone when the volume reaches maximum or minimum level. Short press the knob to play and pause the music.
Switch Mode
Double-click the knob quickly to switch mode between Bluetooth/FM/USBMusic.
FM Tuner
When switching from Bluetooth Mode to FM Tuner, there is a voice prompt
“FMTuner”
- Press the Up/Down button to search the radio station
- Press & hold the Up/Down button to automatically search.
Bluetooth Mode
- When switching from FM mode to Bluetooth Mode, there is a voice prompt “Bluetooth”.
- Press the Next/Previous button to track forward or back forward.
USB Music Mode
- Press the Next/Previous button to track forward or back forward.
Note: The USB Mode can only be switched when there is an external USB audio source connected.
Important Note
Please don’t play the music for over half an hour if you don’t start the
engine, or the battery will be drained quickly. Also if the battery power is
lower than 11V, you cannot power on the speaker.
Download PDF:LEXIN LX-S3 Motorcycle Waterproof Bluetooth Speaker User Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>