COREMORROW E63.C1K Series Piezo Controller User Manual
- June 3, 2024
- COREMORROW
Table of Contents
E63.C1K Series Piezo Controller
User Manual
Version: V1.0
This document describes the following products:
■ E63.C1K Open loop USB 1 channel
DECLARATION
Declaration!
This user manual is a integrated user manual of the E63.C1K series
piezoelectric controller. Please read this user manual carefully before using
this controller. Follow the instructions in the manual during use. If there is
any problem, please contact us for technical support. If you do not follow
this manual or disassemble and modify the product yourself, the company will
not be liable for any consequences arising therefrom. Please read the
following to avoid personal injury and to prevent damage to this product or
any other product connected to it. In order to avoid possible hazards, this
product can only be used within the specified range.
Notice!
Do not touch any exposed ends of the product and its accessories. There is
high voltage inside. Do not open the case without permission. Do not connect
or disconnect input, output, or sensor cables with power on. Please keep
surface of E63.C1K clean and dry, don’t operate in humid or static
environment. After use, output voltage should be cleared to zero before
turning off the controller switch, such as switching the servo state to the
open-loop state.
Danger!
The piezoelectric power amplifier described in this manual is a high-voltage
device capable of outputting high currents, which can cause serious or even
fatal damage if not used properly. It is strongly recommended that you do not
touch any parts that connect to the high voltage output. Special Note: If you
connect it with other products in addition to our company, please follow the
general accident prevention procedures. Operating the high-voltage
amplification requires training professional operators.
Warning!
If the voltage exceeds the PZT’s tolerable range, it will cause permanent
damage to the PZT. Before adding voltage to the PZT poles, it must be ensured
that the positive and negative poles of the PZT are connected correctly and
the operating voltage is within the allowable range of this PZT.
Cautious!
E63.C1K housing should be installed on a horizontal surface in an area with a
3CM air flow area to prevent internal convection in the vertical direction.
Insufficient airflow can cause equipment to overheat or premature instrument
damage.
Introduction
1.1 Features
- 1 channel small size
- USB communication control output
- 5V（USB）power supply
- Peak current 35mA
- Ave current 2.5mA
- Unload bandwidth 1KHz
- Output short circuit protection
1.2 Applicaitons
- Driving piezo actuators
Driving Principle
Appearance
Voltage, Step Time and Load
Notes and suggestions
- E63.C1K cannot be used to drive inductive loads. If the inductive loads are driven, the product may be damaged.
Customer Service
If you have any questions in use, please tell us the following information:
- Product model and relevant number
- The controller model
- Software driver version
- Supporting computer operating system
Contact us
Harbin Core Tomorrow Science & Technology Co., Ltd.
Tel: +86-451-86268790
Email: info@coremorrow.com
Website: www.coremorrow.com
Address: Building I2, No.191 Xuefu Road, Nangang District, Harbin, HLJ, China
CoreMorrow Official and CTO WeChat are below:
_| 
_
---|---
http://weixin.qq.com/r/PEzawqnEyfS2re2h9xku|
https://u.wechat.com/EAOWfcTPsTfQdVIeK41V9hg
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>