WZRELB LN300012 Pure Sine Wave Inverter USER GUIDE
- June 3, 2024
- WZRELB
Table of Contents
WZRELB LN300012 Pure Sine Wave Inverter
Specifications
- PRODUCT DIMENSIONS 6 x 7.2 x 3.6 inches
- ITEM WEIGHT 68 pounds
- DC INPUT : 12V
- DC INPUT RANGE : 10-15VDC
- AC OUTPUT : 120V
- FREQUENCY: 60HZ
- NO LOAD CURRENT DRAW : <1.5A
- LOW VOLTAGE ALARM : 10±0.5V
- LOW VOLTAGE SHUT DOWN : 5±0.5V
- OVER LOAD : Shut off, recover manual
- OVER VOLTAGE SHUT DOWN: 5V
- OVER THERMAL : Shut off output automatically( Over voltage protection)
- OVER HEAT PROTECTION : 2 Cooling Fans Run When It’s Over 120 F
- EFFICIENCY : 85%-90%
- AC REGULATION : 3%
- TOTAL HARMONIC DISTORTION : THD<5%
- TOTAL POWER OUTLETS: 2
- INPUT VOLTAGE: 12 Volts
- BRAND: WZRELB
Introduction
WZRELB 3000w 12v dc to 120v ac pure sine wave power inverter, off-grid solar system, for motorhome, backup power supply for emergency homes, car camping, and other uses.
Stable Results
High-quality materials guarantee a constant and complete AC output. All large, powerfully driven foreign MOSFETs. ensure a real pure sine wave AC output using pure copper inductance, wave form filtering, and inductance. Stronger current may float on the circuit thanks to the 2.00mm PCB, increasing the load capacity.
Minimal interference
delivers incredibly pure sine wave power that is identical to the AC grid power your utility provides. Enhances the performance of AC equipment with low interference technology. A good option for stereo, television, etc. ideal for delicate loads like very accurate equipment.
Complete safety measures
Low voltage, overload, overvoltage, and short circuit Protection against overheating, polarity reversal (fuse), and ground protection against electrical leakage.
Digital LCD Display
To monitor the real operating state, a large and clear MCU LCD Display for DC Volt and AC Volt output is used. Without any problems, you may power multiple devices at once and keep an eye on the voltage variations at all times.
Intelligent and portable temperature
System with two fans that is managed for long-term reliability. It only cycles on when the temperature is over 68 degrees Celsius and is relatively quiet. Bottom-mounted AC ground connection is safe to use. Furthermore, it offers excellent performance for off-grid applications.
Simple operation
Quick connectors allow for simple movement between different units. It can also be applied to wind and solar power systems. Utilize a solar charge controller to charge your battery using a solar panel. Simple plug-and-play.
Application without a grid
Ideal for use in an emergency as long as the battery is fully charged.
Anywhere there is a power outage or cut-off, you can generate your own
electricity for your home. Suitable for solar, RV, truck, cars, or household
use.
Note
Products with electrical plugs are made with American consumers in mind. Because outlets and voltage vary from country to country, this product might need an adapter or converter to be used where you are traveling. Before buying, kindly verify compatibility.
Frequently Asked Questions
Can you directly hook this to multiple solar panels? Will this be able to run 24 hours a day?
Please hook up the solar panels to the charge controller. Solar panels run to your charge controller, charge controller to your batteries and the inverter uses the batteries.
Can I use this in my truck? Or is it strictly for solar applications?
Yes you could BUT the unit will draw 10 TIMES the supplied current. So a coffee pot of 1200 watts draws 10 amperes AC but this 100 amperes from the battery. The battery is flat dead in 20 minutes, 2nd cup of coffee!
What would be the reason for the internal cooling fan to kicking in every couple minutes? And only on devices that can draw 1000w.
It’s cooling the system. I run a cabin with mine. I have 10 @ 100 watt panels and four 155 amp hour deep cycle batteries powering it. No worries. It’s normal. Worry if you don’t hear it going on.
What happens if a device this is powering shorts out?
Shut down. Output current limited.
What gauge wire can be used for the terminal block? Thinking of wiring a 30amp rv plug to it
There are 4 AWG7 cables with 24 inch coming with this inverter .(2 for positive input ,2 for negative input) There is a voltage drop between the battery and the inverter. The thinner and longer the cable, the greater the voltage drop So if the distance between battery and inverter exceeds 24 inch, please thicken the cable.
Does in drain the battery bank if nothing is plugged in?
It drain around 0.9A idling.
Can this be mounted upside down under a shelf?
I have no doubts it can be mounted upside-down.
Is this inverter internally neutral bonded or floating neutral?
The whole thing floats. There is a grounding stud to reference ground. Remember, you are using a battery as input power. The battery and inverter can easily rise above ground
Can you power this up with a PowerStation? If so how would you connect it?
It is Pure Sine Wave Inverter with 12V DC input to 120V AC output and it is off grid only ,pls connect it to a 12v batteries system.
Has anyone had issues with the inverter just stopping? Intended to use it to run my greenhouse for the summer, went out today and it had just quit.
I tried using it for my vacuum cleaner, a no go. I tried using it for my drill, runs great. I am currently using it for my big-screen tv, cable box, fan. Happy! If you are using to run grow lights and or fans, may run hot. If just using regular light bulbs, I say go for it.
What does blinking red light mean?
Red light blinking means NORMAL but the input voltage a little high. The red light ON means fault.
The description says this is an inverter for solar. It also says 15v overvoltage protection. My solar panel will output up to 17. How will it work?
Yes the inverters always have a safety overload factor and 17 V is not enough to overload the inverter.
If I bought a 12 volt version and want to turn this into a 24-volt version, is there a switch on the inside of the inverter that will allow me to do?
No
Can i stack two of these inverters for double power?
No, they are not designed for that.
What’s the terminal block for?
If you want to hard wire it to an electrical circuit or an appliance.