WZRELB RBP300012VCRT 3000W Pure Sine Wave Inverter Installation Guide
- June 8, 2024
- WZRELB
Table of Contents
WZRELB RBP300012VCRT 3000W Pure Sine Wave Inverter
Prepare tools (for 3000W 24VDC 120VAC inverter):
Battery system: 200AH 24V (recommended to use a battery system of not less than 200A) Cables: 4 Cables (2Red 2 Blue or 2 Black, provided by the manufacturer)
Installation steps
- Confirm the positive and negative poles of the battery, install the cables and tighten the screws.
- Find the positive and negative poles of the inverter input terminals, install the cables and tighten them. Red: positive, black: negative.If 4 cables come with the inverter, pls use the all
- Use a multimeter to confirm the inverter input voltage.Make sure the voltage reaches about 24V before turning on the inverter.
- After turning on the inverter, confirm whether the LED display normally displays the input and output voltages.
Notes
- Please make sure your battery is fully charged to prevent the voltage from being too low and the inverter cannot be turned on.
- Please pay attention to the positive and negative poles of the battery and the inverter, do not connect them in reverse.
- Please tighten the screws not to loosen to prevent the current from being unstable.
- Please pay attention to the specification of the cable, it is recommended to use the cable provided by the manufacturer. There is a voltage drop between the battery and the inverter, and the thinner and longer the cable gauge, the greater the voltage drop.
- Our installation demonstration does not add load appliances, when using, please turn on the inverter first then turn on your loads.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>