ZEALOT-S87 Wireless Speaker User Guide

July 3, 2024
ZEALOT

ZEALOT-S87 Wireless Speaker User Guide

Product Information

Specifications

  • Wireless version: V5.2
  • Charging voltage: DC5V 2A
  • Working voltage: 7.4V
  • Transmission distance: 10m
  • Frequency range: 20Hz-20KHz
  • Speaker: 76mm2 + 38mm2
  • SNR (Signal-to-Noise Ratio): 90dB
  • Distortion: [value]

Product Usage Instructions

Initial Setup and Safety Guidelines

  1. Read the user manual carefully before use.
  2. Fully charge the speaker before first use.
  3. Store and use the product at room temperature.
  4. Avoid exposure to fire, high temperature, or direct sunlight.
  5. Keep speaker volume moderate to prevent hearing impairment.
  6. Do not use organic solvents or chemicals to clean the product.
  7. Prevent small particles from entering the product.
  8. Do not disassemble or modify the product structure.

Package Content

Power On

Battery Level Indicators

  • 80%-100%: Green light
  • 40%-70%: Yellow light
  • Below 30%: Red light

Wireless Connection

Pairing Instructions

  1. Turn on the Wireless of your phone and remove ZEALOT-S87 from the Wireless list.
  2. Turn on both speakers within 1m distance of each other.
  3. Press the button on both machines to connect them – a prompt tone indicates success.
  4. Once connected, play music to test synchronization between the speakers.

Equalizer Settings

  1. Bass: Green light is on
  2. Vocal: Orange light is on
  3. Normal

Charging

  1. Use USB charging with DC5V 2A voltage to charge the speaker.

Play

Light

PARTYARD

EQUALIZER

WARNING

  • To ensure correct use and trouble-free operation, please read this user manual carefully first.
  • For the first use, it is recommended to fully charge it.
  • Please use and store the product at room temperature.
  • Do not expose the product to fire, high temperature, direct sunlight, etc.
  • Please keep the speaker volume moderate to avoid temporary or permanent hearing impairment.
  • Do not use organic solvents or other chemicals to clean the product.
  • Do not let small particles enter the product.
  • Do not disassemble the product or make any modifications to the product structure or any part thereof.
  • If the battery is not replaced correctly, there will be an explosion accident, only the same battery type can be replaced.
  • The battery (battery pack) must not be exposed to such sunlight, fire, or similar overheating conditions.
  • Do not throw and drop the product to avoid damage.

FCC Warning

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

  1. this device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Frequently Asked Questions

Q: How do I know when the speaker is fully charged?

A: When the battery level indicator shows a green light continuously, it indicates a fully charged battery.

Q: Can I connect multiple devices to the speaker simultaneously?

A: The speaker can be connected to one device at a time. For multi-device connectivity, consider using a different speaker model with such capabilities.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals