Boxinda B-26 3 In 1 Wireless Charging User Guide
- July 1, 2024
- Boxinda
Table of Contents
3-IN-1
WIRELESS CHARGING
Model: B-26
B-26 3 In 1 Wireless Charging
Preface
Dear user, thank you for choosing our product. In order to further understand
the product,Please read this manual carefully before use. Wishing you a
pleasant experience
Product components and their descriptions
Watches can be taken
Instructions for use
- Place mobile devices that support wireless charging in the wireless charging sensing area for charging;
- Place the AirPod in the wireless charging area for charging;
- According to personal needs, place the Apple or Samsung watch in the corresponding position (indicated by the arrow} Rotate and adjust to find the appropriate watch for wireless charging:
- After charging, remove all charging devices, disconnect the power, and organize and store the products; frequently asked questions
- Why do wireless charging induction products generate heat during charging?
- During the charging process, there wil be a certain amount of magneto electric canversion loss, which will be converted into heat, It is normal for the phane and charger to generate heat.
Proposal:
- When the device is fully charged, please disconnect the charging in a timely manner to avoid prolonged cyclic charging, which may cause the product and charger to continue to heat up;
- When charging your phone, please close the background software and run the software
Matters needing attention
- Can only be used indoors or in dry environments, avoid placing or using in environments with high temperature, humidity, strong static electricity, and strong magnetic fields;
- For your safety, please do not use wet hands to plug and unplug electrical appliances;
- Avoid placing in easily accessible areas for infants and children;
- If the product gets wet or has dirt or dust, please do not use it,
- Non professionals are not allowed to disassemble and repair it without authorization.
Product specifications
Model: B-26
Input: 9V/2.0A,12V/2A
Phone Output: 15W
Earphone Output: 5W
Watch Output: 3W
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate
radiofrequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The FCC certification of this device refers to RF exposure testing performed
in typical operating conditions, where a person is no closer than 20
centimeters from the device surface at all times, except for non-repetitive
patterns with transient time intervals in the order of a second. Only in the
stated conditions, the device is shown to fully comply with the FCC RF
Exposure requirements of KDB 447498.
PDF created with pdfFactory Pro trial version
www.pdffactory.com