nave 30453 PIERRE Standing Lamp Instructions
- October 27, 2023
- nave
Table of Contents
30453 PIERRE Standing Lamp
30452.. ; 30453..
220-240V~ 50Hz
1x E14 max. 40W
IP20
Safety instructions
Electrical connections may only be carried out by expert staff.
The manufactures do not accept responsibility for injuries or defects caused
by improper use of a luminaire. The lamp is only for indoor using. The given
mains voltage may not be exceeded.
Attention! Before beginning any work on the lamp, disconnect it from the mains
power line by removing the fuse or unplugging the power plug. This also
applies to cleaning, maintenance and replacing bulbs. Prior to starting
installation work, de-energise the power line – remove the fuse and/or set the
switch to “OFF. Lamps with transformers may be operated only with the original
transformer. Lamps become very hot in the area of the lighting point.
Therefore, never touch the lamp when it is switched on or still hot. RISK OF
INJURY FROM BURNS! The bulb may be replaced only by competent personnel. Use
only bulbs of the same type and voltage rating.
Lamps are not toys. Children frequently do not recognize the dangers
associated with electric appliances or their packaging. Therefore, you should
keep them away from children. If you give this lamp to someone else, always
include these instructions. If the lamp is damaged, in particular the cord or
lamp socket, discontinue use of the lamp immediately. In the event of a
malfunction, always have the lamp repaired by a qualified electrician. Never
attempt to repair the lamp yourself. Improper repairs can endanger the safety
of the user.
Protection class II This luminaire is particularly insulated and must not be
connected
to a protective earth-terminal.
Pay attention to the fact that electric lines are not damaged during
installation.
Minimum clearance between emitter edge and floodlighted surface >= 0,5 m.
Only replace defective lamps by lamps of the same design, wattage and voltage.
The care of luminaries is restricted to their surfaces. Use only a dry cloth.
Wetness must not get into wiring spaces or to current-carrying parts. Plug and
connection elements must be free of train and trick strengths.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>