momax UD31 Q2.Mag Go 3 In 1 Magnetic Wireless Charging Stand Instruction Manual
- June 27, 2024
- MOMAX
Table of Contents
momax UD31 Q2.Mag Go 3 In 1 Magnetic Wireless Charging Stand
Product Specifications
- Dimensions: 50mm (width) x 80mm (height)
- Model: UD31
Product Usage Instructions
Instruction for Use
To use the product, follow these steps:
- Turn on the device by pressing the power button.
- Adjust settings as needed using the control buttons.
- Refer to the user manual for advanced features and troubleshooting.
FAQ
- Q: How do I dispose of electronic products?
A: To dispose of electronic products, follow these steps:
1. Ensure the product is turned off.
2. Check local regulations for electronic waste disposal methods.
3. Do not dispose of electronic products in regular household waste.
- Q: What are the warning signs associated with the product?
A: Warning signs may include unusual sounds, smells, or behavior from the device. If you notice any of these signs, stop using the product immediately and contact customer support for assistance.
INSTRUCTION MANUAL
Q2.Mag Go
UD31
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
- If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20 cm between the radiator and your body.
INSTRUCTION FOR USE
- Connect Q2.Mag Go to a 35W or higher USB-C PD power adapter.
- Place your Apple Watch, AirPod and Qi-enable device on the wireless charging pad to charge.
- Remove Q2.Mag Go from the power adapter when charging is completed.
SPECIFICATION
MODEL: UD31
- USB-C Input : 5V⎓3A, 9V⎓3A, 12V⎓3A
- Wireless Output 1 : 5W / 7.5W / 15W (max.)
- Wireless Output 2 :5W (max.)
- Wireless Output 3 :5W (max.)
- Material : Silicone Rubber + Magnets Aluminim Alloy
- Size : 66.5 x 66.6 x 28.1mm(Folded)
- Weight : 214g ± 10g
CONTAINS
- Q2.Mag Go Qi2 3-in-1 Magnetic Wireless Charging Stand
- USB-C to USB-C cable(1m)
- Magnetic patch and protective film
- Instruction Manual and Warranty Card
WARNING
- Do not dismantle or modify the product;
- Do not store the product in wet conditions;
- Do not keep or use the product near heat sources;
- Do not let water or any other liquid flows into the minside part of the product’s interface. This would cause damages to the product;
- Make sure to remove metallic or magnetic protective case of your device when charging;
- While charging, the Q2.Mag Go may heat up. This is normal and should not affect Q2.Mag Go,s performance. If the battery feels hot to the touch during this charging process, remove the Q2.Mag Go from the charger and allow it to cool down before restarting the charging process;
- Avoid using bent or damaged USB cable.
DISPOSAL OF ELECTRONIC PRODUCTS
- Do not place the product as household waste;
- Please dispose of discarded electronic products properly according to local regulations.
- MOMAX encourages you to participate in electronics recycling program
WARRANTY CONDITIONS
- For any defect, in the judgment of our technician, caused under normal use, we are responsible for repairing free of charges 12 months commencing from the date of purchase at the discretion of our company;
- A valid warranty card and original purchase invoice must be presented upon request of warranty service
- This warranty card shall not apply to the product if:
- it has explicitly modified or repaired in any way by persons other than technicians of this company, or;
- it has been damaged through misuse, malicious acts, negligence, inflow of any liquid, or;
- losses or damages are caused by force majeure or natural disasters.
- No alteration to this warranty card will be allowed;
- The warranty terms and conditions are subject to change without prior notice;
- Please retain your proof of purchase for warranty service;
- Please consult the dealer about the product compatibility with your cell phone / PDA before purchase. Product specifications are subject to change without prior notice;
- Please visit www.momax.net for latest product information.
WARRANTY
- Model
- Date of Purchas
- Remark
- Customer Service
- Hong Kong and Macau:
- Unit A, 4/F.,Cheung Lung Ind. Budg.,
- Lai Chi Kok, Kowloon, Hong Kong10 Cheung Yee Street, Hotline: 852-2402 3186
- E-Mail: info@momax.net
- info@momax.net.cn
- Copyright© 2024 MOMAX Technology Ltd. All rights reserved. MOMAX is registered trademark of MOMAX Technology Ltd. All other trademarks are the property of their respective owners.
©2024 MOMAX Technology Ltd