MOMAX Q.Mag Pro 3 3 in 1 Wireless Charge Stand User Manual
- June 12, 2024
- MOMAX
Table of Contents
MOMAX Q.Mag Pro 3 3 in 1 Wireless Charge Stand
PRODUCT DIAGRAM
Thank you for choosing our Wireless Charging Station, please read this manual carefully and keep it properly before you use it.
PRODUCT SPECS
- Product name: 3 in 1 Wireless Charge Stand Model#: 802962
- Interface: Type-C
- Input: 9V/3A, 12V/2.25A
- Phone Output: SW/7.SW/lOW/lSW Max Material: PC+ABS+Zinc alloy Magnetic Load-bearing: 11009 Size: 157x90x123.8mm
- Weight: 260g
- Supports: iPhone 12/13/14, Airpods 2/3/Pro/Pro 2, Apple Watch 3-8/SE/Ultra, and Qi standard wireless charging equipment
WHAT’S IN THE BOX
- lx – Wireless charger
- lx – User manual
- lx – 3ft Charging cable
INSTRUCTIONS
- Connect the USB-C end of the charging cable to a wall charger (sold separately) and the USB-C end to the back of the charging stand. For watch charging: Place the watch in the designated charging area, and the washer will automatically secure it for charging. (The watch will audibly click to indicate successful charging initiation.)
- Place the mobile phone in the transmitting area, ensuring that the receiving area of the phone aligns with the wireless charger’s transmitting area, typically located in the middle of the phone. The product’s green light will remain illuminated during this process.
- Position the case of the wireless-enabled earbuds in the wireless charging area, aligning the charging surface of the case with the product’s transmitting area. The product’s blue light will remain illuminated during this process.
FCC WARNING STATEMENT
Warning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 15&20cm between the radiator and your body.
IMPORTANT SAFETY INSTRUCTIONS
-
Ttehmisp product is suitable for use within the Stor mature range of 0° to 35° (32°F to 95°F). (-4 age temperature is -20° to 60°C ° F to 140° F)
-
Asuvnolid using or storing this product in direct height, near heating equipment, or in other high-temperature environments. Do not immerse in water.
-
Doro r not attempt to disassemble air it yourself.
-
Supervise children when using this product.
-
5. oKre eopb jtehcet sw. Airevoleisds charging area clear of metal (e.g., credit c acing magnetic stripe cards, phone cards, bank books,
tapered recently did cards) near the wireless charger to damage from the magnetic field. :c -
No guarantee can be applied in case of misuse.
-
The manufacturer declines all responsibility for safety instructions.
PRODUCT MARKINGS
- CE marking European Conformity complies with EU requirements, such as EU directives and standards.
- This product is designed to minimize potential interference with other electronic devices and is in accordance with FCC guidelines.
- Simple”/ Designed in Orange County, CA, 19800 MacArthur Blvd. Suite 300, Irvine California, 92612 / United States of America
How do I activate my FREE upgraded limited lifetime replacement warranty?
- Scan QR code to install the InstaProtek app
- Follow the steps to register your product
Registration is required for a Limited Lifetime Replacement Warranty. A standard 1-year manufacturer warranty applies if not registered. See website for details.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>