Yongxin YX-492 Retractable Cable Car Holder User Manual

: June 26, 2024
: Yongxin

Table of Contents

Yongxin YX-492 Retractable Cable Car Holder User Manual
Product Specifications
Product Usage Instructions
Operating Instructions
Safety Precautions
Product Specifications
Product introduction
Installation
FCC Statement
Frequently Asked Questions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Yongxin YX-492 Retractable Cable Car Holder User Manual

Product Specifications

Compliance: Part 15 of FCC Rules
Operating Conditions: Must not cause harmful interference; must accept any received interference
Antenna: Ensure proper separation between equipment and receiver
Radiation Exposure Limit: Complies with FCC standards for an uncontrolled environment
Minimum Distance: 20cm between radiator and body during installation and operation

Product Usage Instructions

Installation Guidelines

Make sure to follow these steps during installation:

Do not make any changes or modifications to the unit without explicit approval to maintain compliance.
Connect the equipment to a power outlet on a separate circuit from the receiver.
Consult a qualified radio/TV technician if you experience interference issues.

Operating Instructions

Follow these guidelines for proper operation

Avoid causing harmful interference while operating the device.
Maintain a minimum distance of 20cm between the radiator and your body during use.
Ensure the equipment and receiver are properly separated to prevent interference.

Safety Precautions

For safety, remember to:

Follow all FCC radiation exposure limits set for uncontrolled environments.
Avoid modifying the unit in ways that may impact compliance or safety.

Product Specifications

Name:magnetic car wireless charger Material:ABS+ TPU+magnet
lnput:9V/2A, 12V/1.67A
output:15W/10W/7.5W/5W

Product introduction

Wireless charging area
TypeC
USB
Tail clamp

Installation

Clip the tail clamp onto the most suitable spot of the air vent.
Connectthe cable of wireless charging to the car charging or USB port.
Place the phone with magnet plate into the mount,or stick a iron sheet on the back of Android phones.

Warning

Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

The equipment complies with FCC Radiation exposure limit set forth for uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.