WINCO GENERATORS TPH250 Three Point Hitch Installation Guide

June 26, 2024
WINCO GENERATORS

WINCO GENERATORS TPH250 Three Point Hitch Installation Guide

REQUIRED TOOLS:
TAPE MEASURE
SOCKET & WRENCH SIZES:
• 9/16 IN
• 3/4 IN
• 1 3/16 IN

PARTS BAG

STEP 1
  • With the base plate (16) bottom side up, secure the isolators (9) to the four foots of the base plate using 48178- 000 (20) and 16248-001 (4). The nut will install at the bottom of the isolator.
  • Flip the base over.

Note: You may also install casters in lieu of the isolators. The hole size is 11/16” diam.

STEP 2
  • Install the left and right side panels (13)(14). The panel cradle will sit under the base. Use 441-000 (18) and 526-000 (21) from the outside and secure with a 526-000 (21) and 47136-000 (19) on the inside. See pictures.

NOTE: The four holes are the front of the TPH250.

STEP 3
  • The draw pin bracket (15) installs on the bottom of the side panels, behind the panel cradle. Use 441-000 (18) and 526-000 (21) on the outside and secure with 526-000 (21) and 47136-000 (19).

NOTE: The flat part of the bracket is the bottom.

  • The draw pin (6) comes with the washer and nut attached. Remove the nut and washer and install into the bracket holes of the draw pin bracket (15).

  • Insert a lynch pin (8) to the draw pin.

STEP 4
  • The top cross member (11) installs on the top of the side panels, behind the panel cradle. Use 441-000 (18) and 526-000 (21) on the outside and secure with 526-000 (21) and 47136-000 (19).

NOTE: The three holes of the top cross member should be two on bottom and one on top when installing.

  • Install the top link bracket (12) to the top cross member (11) using 91658- 001 (25), 526-000 (21), and 56854- 000 (22).

  • Install the top link pin (7) through the bracket. Secure with a lynch pin (8).

COMPLETED TPH250

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals