HolyHah Luck Jingle 304dpi Mini Printer User Guide
- June 4, 2024
- HolyHah
Table of Contents
**HolyHah**
Luck Jingle 304dpi Mini Printer
**User Guide
**
LuckJingle mini printer quick start guide
Usage status
ON/OFF
Press and hold the power key for 3 seconds to turn ON /OFF.
The green light on: ON/ Standby
Charging state
It is recommended to fully charge for the first time after purchase.
Red flashing: low power
The red light on charging
The green light on charging is completed
Equipment abnormal status
Red light always on: paper shortage / over temperature/cover opening.
The orange light is always on: enter the printer debugging mode, press,
and hold the power key until the printer is shut down to exit.
App download and settings
Mobile Download
Search “Luck Jingle” in the App Store Settings
Double-click the power button, the printer will print out the QR code of the
bound device; add a device through the App, scan and scan the QR code to
connect to the printer (Note: Do not search for Bluetooth printer connection
in the Bluetooth settings of the mobile phone)
Replacement of consumables
- Cover opening: look at the arrow direction as shown in the figure, and push down the upper cover to open the cover
- Consumables: in the direction shown in the figure, put the heat-sensitive surface of the paper on the same side as the heat-sensitive head
- Close the cover: after the consumables are put in, push the upper cover upward as shown in the figure. and then close the cover
Please do not touch the print head directly to mead damage. especially after printing, do not touch the print head directly to prevent overheating and scalding.
Safety and precautions
- There is a built-in lithium battery, please do not use it in an environment with temperatures higher than 40 C: keep away from fire and other heat sources, and do not place it in the hot sun, such as in a closed car;
- Children should be charged and used under the supervision of adults. After full charge, please make sure to pull out the charging line in time to prevent overheating, short circuit, or fire;
- Do not put the product in fire or water to avoid battery short circuit or fire or bum:
- The operating temperature range is 0 ‘C to 40 ‘C, please do not exceed the recommended temperature range:
- If you suspect that there is a problem with the battery, please contact the after-sales service center for assistance.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1)This device may not cause harmful
interference. (2)This device must accept any interference received, including
interference that may cause undesired operation. 2. Changes or modifications
not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and,if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.if this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>