Sinope WL4210-C4 Smart Water Leak Detector Installation Guide

Table of Contents

Sinope-WL4210-C4-Smart-Water-Leak-Detector-PRODUCT-
IMAGE

Product Specifications:

Remove the cover and pull out the battery tab to activate the device.
Depending on the model, connect the accessory to the detector.
To open a connectivity session, refer to the instruction manual of your Control4 controller.
Press the detector’s connection button to initiate connection: Light Status:
- Green light blinks: Device is connecting
- Green light lit for 10 s: Successful connection
- Red light turns on: Connection has failed*

Refer to the Support section of our Website at www.sinopetech.com for assistance in case of failed connection.

Testing the Smart Water Leak Detector:

Test the detector by putting the electrodes in contact with a small amount of water (1 tsp). The audible alarm will be activated. Wipe the electrodes with a dry cloth to cease the alarm.
If the alarm isn’t activated, refer to our Website for troubleshooting.

Frequently Asked Questions (FAQ):

Q: What should I do if the detector does not emit an audible alarm when water is detected?
A: If the alarm isn’t activated, refer to our Website for troubleshooting steps or contact our customer support for assistance.
Q: How can I connect the detector to a Control4 home automation system?
A: To connect the detector to a Control4 system, follow the steps outlined in the instruction manual provided with your Control4 controller.
Q: What is the purpose of the remote probe and perimeter cable in specific models?
A: The remote probe and perimeter cable in specific models provide extended reach for detecting water leaks in different areas.

WL4210-C4, WL4210S-C4 WL4210C-C4
Installation Guide
Smart Water Leak Detector

Audible alarm
The detector emits an alarm when water is detected by the electrodes or if batteries are low.

$Sinope-WL4210-C4-Smart-Water-Leak-Detector- $5$$ $Sinope-WL4210-C4-Smart-Water-Leak-Detector- $6$$

Remove the cover and pull out the battery tab to activate the device.
Depending on the model, connect the accessory to the detector.
To open a connectivity session, refer to the instruction manual of your Control4 controller
Press the detector’s connection button.

Refer to the “Support” section of our Website at www.sinopetech.com.

Test the detector by putting the electrodes in contact with a small amount of water (1 tsp). The audible alarm will be activated. Wipe the electrodes with a dry cloth to cease the alarm.
If the alarm isn’t activated, refer to our Website.

$Sinope-WL4210-C4-Smart-Water-Leak-Detector- $10$$

Protect your belongings and avoid the inconvenience caused by water damage.

This product emits an audible alarm and sends an alert message via 4Sight® when a water leak or a drop in temperature is detected or when the batteries are low*
Required the Control4® app and a subscription to 4Sight®
Combine this product with one of Sinopé’s Control4® valves so that your water is shut off as soon as a leak is detected.

For more information, visit our Website: www.sinopetech.com.