navLinkz VSA-ME16 AHD Vehicle Specific Camera Instructions
- June 22, 2024
- NavLinkz
Table of Contents
navLinkz VSA-ME16 AHD Vehicle Specific Camera
Specifications
- Connection Cable: 0.40m
- AHD Vehicle-specific camera: VSA-ME16
- Exchange rear door opener handle with integrated camera
- System Cable Extension: 8.10m
- Installation: from 12V to 12V
- Video Signal Throughput: Male 4pin-BM
- +12V Reverse Signal
- Ground
- +12V Power Supply Camera
- Camera not suitable for permanent operation!
AHD Vehicle-specific camera
Product Usage Instructions
Installation
- Ensure the power supply is 12V to 12V.
- Connect the provided connection cable and system cable extension as per the manual.
- For a stable power supply when using a reverse signal, install a relay between the power supply of the reverse signal and the camera’s power supply.
The camera is not suitable for permanent operation!
Note: If the camera is powered by a reverse signal we recommend
installing a relay between the power supply of the reverse signal and the
power supply of the camera to ensure a stable and uninterrupted power supply
and avoid unwanted errors in the board computer.
Camera Configuration
Cut cable loops if required and choose between guide-lines or no guide-lines
as per preference.
- With guide-lines
- Without guide-lines
Important Notes
- Do not clean the rear-view camera with a steam cleaner.
- If the camera’s isolation is compromised, repair it promptly to prevent moisture from entering.
Product features
- Sensor type AHD NTSC CMOS
- Resolution 1080p
- Light sensitivity 0.2 Lux
- Frame rate up to 30fps
- Angle h=140°, v=85°, d=170°
- Mirrored image (fixed)
- Guide-lines can be switched off
- System cable with throughput, e.g. for reverse signal
- Protection class IP68
- Operating voltage +12V DC (6 ~ 16V)
- Operating voltage camera +12V DC
- Current consumption max. 70mAh
- Video connector RCA male connector
- System connector camera 4pin-BM
- Diameter camera connector 5mm
- Total cable length 10m
- Operating temperature range –20°C to +70°C
- Storage temeprature range -40°C to +85°C
Tip for dealers: Inform your end customers that the rear-view camera mustn‘t be cleaned by steam cleaner!
In case the isolation of the camera is harmed in the moisture section close to the camera, it is mandatory to repair the isolation. Otherwise the camera will inevitably become moist inside sooner or later.
FAQ
Q: Can the camera be operated continuously?
A: No, the camera is not suitable for permanent operation to avoid damage.
Q: What should be done if the camera isolation is damaged?
A: It is essential to repair the isolation to prevent moisture from affecting
the camera’s performance.
NavLinkz GmbH
Heidberghof 2
47495 Rheinberg
Germany
www.navlinkz.de
mail@navlinkz.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>