NavLinkz VAN-REN03-A Brake Light with Rear View Camera Instruction Manual
- May 15, 2024
- NavLinkz
Table of Contents
Brake light with rear-view camera
VAN-REN03-A
Delivery content
Installation
Note: If the camera is
powered by reverse gear lamp signal, we recommend to install a relay between
the power supply of the reverse signal and the power supply of the camera, to
ensure a stable and uninterrupted power supply and to avoid vehicle computer
errors. The throughput wire can be used to connect the reverse gear lamp
signal from back to front.
In case the isolation of the camera is harmed in the moisture section close to
the camera, it is mandatory to repair the isolation. Otherwise the camera will
inevitably become moist inside sooner or later.
Do not expose camera to high pressure cleaners.
Produkt features
- Camera in vehicle-specific 3rd brake light
- Mounted by exchanging the factory 3rd brake light
- LED illumination integrated
- Camera position fixed
- Sensor-type CMOS 1/4 inch AHD NTSC
- Resolution 720p
- Aperture F1.36
- Light sensitivity 0.02 Lux
- Angle H=120°, V=80°, D=150°
- Mirrored picture (fixed)
- Protection class IP69
- Mini 4pin-BM system harness, integrated throughput wire (blue)
- 11.20m total system cable length, consists of:
– 0.80m cable fixed on camera to female 4pin-BM (Ø 5mm)
– 10.00m extension cable male 4pin-BM to female 4pin-BM
– 0.40m adapter male 4pin-BM to male RCA and power wires
Specifications
- Brake light grub screw 141 x 55 x 114mm (W x H x D)
- Operating voltage +12V DC
- Current consumption max. 50mA
- Suitable for permanent power (ACC)
- Operating temperature range -30°C bis +75°C
- Storage temperature range -40°C bis +80°C
NavLinkz GmbH
Heidberghof 2
47495 Rheinberg
Germany
www.navlinkz.de
mail@navlinkz.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>